ICY ICY3727TC User manual

Installation Manual
ICY3727TC for ICY-Thermostat
ICY3728TC for Universal Thermostat
Temperature Controller

The temperature controller is designed to connect a gas heater to a
thermostat. Below shows in 7 short steps how that should be done.
Open the box and take out the bag of screws.1.
Place the heater’s temperature gauge on the aluminum bracket.2.
Cover it with insulation foil and close the clamps. Ensure that the
gauge is well pressed against the angle bar.(see gure below).
Connect the wires of the thermostat to the two screw terminals next3.
to the power adapter plug. (see gure below).
Introduction
Installation
I.C.Y. B.V.

Connect the power adapter to the round plug. (see gure below).4.
Place the black sealing plate over the wires and close the box with5.
the given screws.
Place the temperature controller preferably upright with the cool-6.
ns vertical.
Turn heater knob on maximum. Make sure that the thermostat is7.
not asking for heat. If the heater doesn’t stop after 10 minutes
turn the heater knob so far back that the heater just turns off. The
heater responds within 3 to 5 minutes depending on the type of
heater and temperatue gauge.
ATTENTION! In the event of a power failure the heater will start
heating.
I.C.Y. B.V.

I.C.Y. B.V.
© I.C.Y. B.V. 2011 wijzigingen voorbehouden
Versienummer: 2011-1