HACIENDA
LED Light Fixture
10
HACIENDA
LED Light Fixture
11
First ensure the unit is secure and steady before use; deploy the LED-module about 15- 30cm above the top
of the plants; Connect the LED-module with a timer and program the desired lighting cycle. Alternatively:
Connect the device with the provided wires to the electric grid. Change the desired light-output and
eciency through various operation patterns with the toggle switches on the device. Deploy the module at a
higher point to illuminate a larger surface. Please ensure that the LED-module is being operated out of sight
and reach of children and animals to protect their eyes!
Operate the LED-module only horizontally, while hanging or slightly angled (approx. about 20°). Do not
use the LED-module vertically or as illumination device upside-down (direct eye contact and long exposure
over time may cause permanent damage to your eyesight!). Keep the module clean to ensure a long lasting
lifetime, especially the air intakes should be cleaned on a regular basis.
Please ensure the LED-module is always operated out of direct sight and whilst wearing LED protective
glasses.
Warning! This LED-module is powered with electricity (220V AC)!
To prevent Injury, we ask you to desist from Improper usel
4.1. SAFETY MEASURES & PRECAUTION
4. OPERATION
4.2. PUTTING INTO USE
4.3. PROPER USE
4.4. PROTECTION
Never deploy the LED-module outdoors or In damp rooms! Operation exclusively indoors.
Prevent exposure to water!
Never open the case of the device! Health hazards await the consumer and the warranty of
the device expires.
Never remove the electric supply abruptly! Ensure that the device is switched o with the
switches on the unit before unplugging at the wall
Do not block the air intakes and vents on the device (a minimum distance of approximately
20cm to all sides is considered best!). Keep the device clean to ensure longevity of the
product
NOTES
Please use this page to make notes for a later date.
