FCC/ISED Regulatory no ces
Modifi ca on statement
IKUSI ELECTRONICA, S.L. has not approved any changes or modifi ca ons to this device by the user. Any changes or
modifi ca ons could void the user’s authority to operate the equipment.
IKUSI ELECTRONICA, S.L. n’approuve aucune modifi ca on apportée à l’appareil par l’u lisateur, quelle qu’en soit la na-
ture. Tout changement ou modifi ca on peuvent annuler le droit d’u lisa on de l’appareil par l’u lisateur.
Interference statement (if it is not placed in the device)
This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Opera on is
subject to the following two condi ons: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired opera on of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploita on est autorisée aux deux condi ons suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’u lisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscep ble d’en
comprome re le fonc onnement.
Wireless no ce
This device complies with FCC/ISED radia on exposure limits set forth for an uncontrolled environment and meets the
FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules.
This transmi er must not be co-located or opera ng in conjunc on with any other antenna or transmi er.
Le présent appareil est conforme à l’exposi on aux radia ons FCC / ISED défi nies pour un environnement non contrôlé
et répond aux direc ves d’exposi on de la fréquence de la FCC radiofréquence (RF) et RSS-102 de la fréquence radio
(RF) ISED règles d’exposi on.
L’émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur.Ç
FCC Class B digital device no ce
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protec on against harmful interference in a residen al
installa on. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruc ons, may cause harmful interference to radio communica ons. However, there is no guar-
antee that interference will not occur in a par cular installa on. If this equipment does cause harmful interference to
radio or television recep on, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separa on between the equipment and receiver.
- Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
