
version: july. 2018 - www.ilo-benelux.com
1. IMPORTANT SAFETY INSTRUCTIONS
Instructions should be carefully read before installation and retained by the user. The booklet must
be keeped and delivered to the new user in case of cession of the machine. The Manufacturer
reserves the right to vary the features of the product without prior notice. The technical data are
merely indicative.
1. This appliance is intended solely for the use it has been designed for, namely room and
people heating. The Manufacturer is not responsible for any damage that could happen for improper
use.
2. After unpacking make sure that the appliance is complete and shows no signs of visible
damage or tampering.
3. Keep packing materials, which are potential dangers, away from children.
4. The device can be used by children at least 8 years (as well as by persons with reduced
physical, sensory or mental capabilities, or lack of experience or required knowledge) provided that
they are under surveillance, or after they have been instructed relating to the safe use and have
understood the potential dangers. Children should not play with the appliance. Cleaning and
maintenance must be performed by the user and not by unsupervised children.
5. Before connecting the appliance make sure that the voltage is the same as indicated on the
device and the line supply is corresponding to the effective rules.
6. Do not use in presence of gas, inflammable or explosive liquids or substances. Defined in
BS5345.
7. Some fundamental rules which apply to all electrical devices must be observed when using
the heater:
8. Do not touch the heather with wet hands.
9. Do not handle with bare feet.
10. Do not let children play with the electrical appliance.
11. Avoid the use of an extension cord with this product, because the extension cord may
overheat and cause a risk of fire.
12. Do not apply any modification to the product.
13. Keep connections dry.
14. If the power supply cord is damaged, avoid to use the appliance. For power cord replacing,
please contact the manufacturer or the technical service or a person with similar qualification, in
order to avoid any risk.
15. If the appliance is not used for a long period, disconnect it from the power supply.
16. Always disconnect the appliance before doing any maintenance operation.
2. ELECTRICAL INSTALLATION
In models with cable without plug the installation should always be carried out by a
qualified electrician or a competent person in accordance with the standards HD 384
CENELEC for Europe, or international IEC 60346-7-708 1988. The energy supply
must be done through a properly grounded socket
The appliance must be connected to supply line by means of the provided H05SS-F
silicone cable. An overvoltage category III bipolar circuit breaker with contact opening distance of at
least 3 mm must be fitted upstream from the supply line.
• The heaters should always be installed only using the mounting brackets provided or supplied
as fittings.