IMade3D JellyBOX User manual

In this guide, we attach Left filament fan to the X carriage.
_________________________________________________________________
Left Filament Fan
You'll need:
Green left filament fan shroud
Pink left filament fan mount
Plastite screw (5)
30mm fan
Alert: If you're building Dual Fan JellyBOX, use the 30mm fan with a long wire.
Connect the green filament fan shroud and the pink shroud mount with a single
plastite screw.
#prep X Assembly 02: Left Fan
Page 1

Attach a small 30mm filament fan to the shroud with four plastite screws.
Pay attention to the orientation of the fan in reference to the fan cable. Align the
fan so that the wires extend to the lower right when looking straight at the shroud.
Attach the Fan to the X Assembly
Page 2

Title: Attach the Left Fan to the X Assembly
You'll Need:
X Assembly (1)
Left Fan Assembly (1)
M3x12 bolt (1)
M3 regular washer (1)
M3 regular bolt (1)
Page 3

Title: Run the Wire Through the X Carriage
Place the wire from the fan in the slot running along the bottom of the carriage.
Page 4

Title: Place M3 Nut in the X Carriage
Place a regular M3 nut in the slot on the left side of the X carriage next to the belt.
Pro Tip: turn the x assembly on a side and let the gravity do the work for you. Drop
in the nut with tweezers
Page 5

Attach the Left Fan to the X Carriage with an M3x12 bolt and M3 washer.
The M3x12 bolt in the fan mount reaches through to the nut in the slot.
Tighten it using an M3 hex key.
Page 6