
9. How to start-up with SM-USB-Module?
Install USB-Driver (from USB-Stick)
Connect the SM-USB to the PC and the installation will be accomplished
automatically
Install TrimeTool software (from USB-Stick)
Check the setting of the COM-Port in the device manager and setup the specific
COM-Port in the TrimeTool software (COM1-COM9 possible)
Connect your sensor to the SM-USB either via RS485 or via IMP-Bus
Run TrimeTool software and Scan bus
The sensor has to be shown in the module list
10.Technical Data:
Power consumption
(IDLE):
Current max.
(protected):
External power (to
sensor):
Power supply cable with banana plugs (1,8m)
USB-Stick with driver and software
Optional available
accessories:
Adapter screw terminal 7-pin male connector (RS485)
Adapter screw terminal 4-pin male connector (IMP-Bus)
Power supply out of USB only for single sensor!
For multiple sensors use external power supply!
For SONO-Series always external power required!
11.Contact Information
Should you have any queries please don’t hesitate to contact your local distributor or
address directly to IMKO:
IMKO Micromodultechnik GmbH
Im Stoeck 2
D-76275 Ettlingen
Germany
Phone: +49-7243-5921-0
Fax: +49-7243-90856
Internet: http://www.imko.de