Indel Webasto Marine Isotherm IS-SGC00473AA Instruction sheet

How to install the divider kit on the drawer 160

Upper drawer

Insert the long grid in the preset holes

Use the positioning grid to keep the long grid in place

Center the long grid and position it parallel to the bottom

Mark the position of the holes to fix the dividing grid

Use Ø4mm drill

Use the plastic rivets to fix the dividing grid

Put the top basket in. The installation for the upper drawer is over

Lower drawer

Put the short grid in and use both dividing grids to keep it in place. Center the short
grid

If possible remove the door and put it on a flat surface to ease the installation
process. Put the dividing grid parallel to the drawer and center it to the short grid

Mark the position of the holes to fix the dividing grid

Use Ø4mm drill

Use the plastic rivets to fix the dividing grid

Repeat the operation for the other grid keeping in mind that the holes will run
through the back of the drawer

Once the installation of the other grid is done the fridge is ready to be used