
6
COLLEGAMENTO
E’ bene che tutti i collegamenti
siano fatti con l’amplicatore
spento.
Vericate che l’impedenza di
carico non sia inferiore a quella
accettata dall’amplicatore.
Collegate i diffusori all’amplica-
tore con cavo di buona qualità,
di sezione proporzionata alla
lunghezza: 2.5 millimetri quadri
sino a tre metri; 4.0 millimetri per
lunghezze superiori.
LINKING
All connections should be made
with the amplier switched off.
Check that the load impedance is
not lower than the amplier can
accept.
Link the speakers by using good
quality cables; the cable cross sec-
tion have to be proportionate to
the length: 2.5 square millimeters
up to three metres; 4.0 millimeters
for greater lengths.
BEKÖTÉS
Minden csatlakozást az erősítő
kikapcsolt állapotában kell
elvégezni. Ellenőrizze, hogy a
terhelés impedanciája nem
alacsonyabb, mint amit az erősítő
el tud fogadni.
A hangsugárzókat jó minőségű
kábelekkel kösse össze; a kábel
keresztmetszetének arányosnak
kell lennie a hosszal: 2,5mm2
három méterig; 4mm2 nagyobb
hosszúság esetén.
Rispettate le polarità: eventuali
errori di fase (inversione di polari-
tà) possono ridurre le prestazioni
del sistema audio. Abitualmente il
colore rosso e/o il segno “+” indi-
cano il positivo, il colore nero e/o
il segno “-” indicano il negativo.
Keep the polarities: in the event
of wrong phase (opposite polarity)
the performances of the audio
system can be reduced. Usually
the positive is marked with the
red color and/or the “+” sign, the
negative with the black and/or the
“-” sign.
Tartsa be a polaritást: rossz
fázis (ellentétes polaritás)
esetén az audió rendszer
teljesítménye csökkenhet.
Általában a pozitívot piros
színnel és / vagy a "+" jellel, a
negatívot fekete színnel és /
vagy a "-" jellel jelölik.
amplicatore
amplier
erősítő
diffusore
speaker
hangsugárzó
Vericate che nessun lo metta in
cortocircuito le uscite degli alto-
parlanti. Controllate che imorsetti
dei diffusori siano ben serrati.
Ensure that no stray strands of
wire are shorting speaker outputs
together. Check that the loud-
speaker terminals are tight.
Győződjön meg róla, hogy a
hangsugárzó kimenetei nem
zárják rövidre a kóbor
vezetékszálakat. Ellenőrizze,
hogy a hangsugárzó kapcsok
megfelelően meg lettek húzva.