Infineon CY8CPROTO-062S2-43439 User manual

Document Number: 002-36468 REV. **
Date: 02/2023
Published by Infineon Technologies AG
81726 Munich, Germany
© 2023 Infineon Technologies AG.
All Rights Reserved.
Quick start guide
PSoCTM 62S2 Wi-Fi Bluetooth® prototyping kit
CY8CPROTO-062S2-43439
Low-cost hardware platform that enables design and debug of PSoC™ 6 MCUs
1. Before you start, ensure that you have the following:
• PC with USB port and Wi-Fi connectivity
• UART terminal soware such as Tera Term or Minicom
• Non-enterprise Wi-Fi network with internet access or a mobile hotspot
2. Download and install the required soware from the kit webpage
3. Ensure that jumper J3 is at position 2–3 to select 3.3 V.
4. Connect the KitProg3 USB connector (J8) to your PC.
5. Wait for the driver installation to complete.
6. Open the UART terminal soware and connect to the KitProg3 USB-UART
COM port with the following settings:
Baud rate: 115200, Data: 8 bit, Parity: None, Stop bit: 1 bit, Flow control: None.
7. Press the RESET switch (SW1) on the kit.
8. Follow the instructions displayed on the UART terminal to use the
pre-programmed code example. Refer to the kit guide available at the kit webpage for details.
For more information, please visit: www.infineon.com/CY8CPROTO-062S2-43439
RESET switch (SW1)
KitProg3 USB connector (J8)
Power selection
jumper (J3)

PSoC™ Rocks!

Contents under the label
PSoC™ 62S2 Wi-Fi Bluetooth® prototyping kit
CY8CPROTO-062S2-43439