Ingersoll-Rand VON DUPRIN 33 Series User manual

INSTALLATION INSTRUCTIONS
33/35 & 98/99 SERIES END CAP RETROFIT KIT
911390_00(1) Copyright © 2001 Ingersoll-Rand Company. All rights reser ed.
END CAP
VON DUPRIN®
REMOVE OLD END CAP AND END CAP
MOUNTING BRACKET.
REMOVE OLD ANTI-RATTLE CLIP.
PARTS LIST
1
2
INSTALL NEW ANTI-RATTLE CLIP.
ANTI-RATTLE
CLIP INSIDE
2
MINIMUM
3
INSTALL NEW MOUNTING BRACKET AND
END CAP.
4
VERIFY ALL EDGES ARE ALIGNED PROPERLY
AND ARE FREE OF BURRS.
5
IF DEVICE HAS BEEN CUT TO FIT DOOR, CUT MUST BE
SQUARE FOR PROPER END CAP FIT. IF DEVICE HAS
NOT BEEN CUT SQUARE, IT MAY BE NECESSARY TO
REMOVE DEVICE FROM DOOR AND MAKE A CLEAN
CUT FOR PROPER END CAP ALIGNMENT.
NOTE
!
ANTI-RATTLE CLIP
ANTI-RATTLE
CLIP
END CAP MOUNTING
BRACKET
#10-16 X 3/ 
T-CUT SCREW
#10-24 X 1-1/  MTG. SCREW
#10-24 X 3/4 MTG. SCREW

IF NEW END CAP HAS A GAP AS SHOWN BELOW ( ):
THE FOLLOWING METHOD CAN BE USED TO HELP CORRECT IT.
THIS METHOD WORKS ON 98/99 SERIES DEVICES.
A
BREMOVE END CAP AND LOOSEN TWO END CAP
MOUNTING BRACKET SCREWS.
CREMOVE CENTER CASE COVER AND LOOSEN TWO
MECHANISM CASE SCREWS. SLIDE CASE TOWARD
END CAP AS SHOWN.
A
GAP DSLIDE MECHANISM CASE TOWARD END CAP
BRACKET UNTIL IT STOPS AGAINST BRACKET.
TIGHTEN TWO SCREWS.
FTIGHTEN TWO MECHANISM CASE SCREWS AND
REINSTALL CENTER CASE COVER.
EREINSTALL END CAP AND VERIFY THAT GAP IS
CLOSED AND ALL EDGES ARE FLUSH.
CENTER CASE
COVER
MECHANISM
CASE
2
VERIFY THAT
MECHANISM
CASE AND END
CAP BRACKET
HAS NO GAP