Ingrasys iPoMan II-1200 User manual

Quick Installation Guide
Windows Users
R
Re ev vi is si io on n: : A A
N
No ov ve em mb be er r, , 2 20 00 07 7

~iPoMan II 1200 Quick Installation Guide~
- 1 -
Getting Started
The following procedure describes the basic steps needed
to set up the iPoMan II 1200:
1. To set the mode of operation for the iPoMan II 1200
(S1 =off, S2= off). To set up the hardware, connect power
to the power inlet and output devices to the power outlets.
2. To configure the iPoMan II 1200, you can use the console
(HyperTerminal) or WAN port. Connect the iPoMan II 1200 to a
console and a WAN to enable its configuration through the
console or browser menu.
3. Follow these steps to start HyperTerminal and communicate with the iPoMan II 1200:
1. To start HyperTerminal, click Start , Programs , Accessories , Communications , and HyperTerminal from
the Windows
Start button.
2. A New Connection opens. Type a name for the connection in
the
Name field and select an icon for the connection. Click OK
when done.
3. From the Connect using drop-down box, select the COM port
that you have connected to the iPoMan II 1200. Click OK
when done.
4. The Properties window opens. Click Restore Defaults to use
the default settings. Make sure that the
Bits per second field is
set to 9600. Click
OK when done.
5. Press any key. The iPoMan II 1200 Configuration Utility
Main menu
opens and you are prompted for a password. Type
the default password (
admin ) and press Enter to continue. The
main menu options are displayed.

~iPoMan II 1200 Quick Installation Guide~
- 2 -
4. Select the System Group submenu under the
iPoMan II 1200 Configuration to set up the IP
Address, Gateway Address, Network Mask and the
System Date/Time. This IP address will be used while
accessing the web interface to configure the iPoMan II
1200 parameters.
5. After connecting to WAN, open a browser from a PC in the network and use the iPoMan II 1200 IP
address specified through the console menu to open the web interface for system configuration.

~iPoMan II 1200 Quick Installation Guide~
- 3 -
Connecting EMD
An Environmental Monitored Device (EMD) that is connected to sensors for detecting temperature,
humidity, water level, and so on can be connected to the iPoMan II 1200 with the console port. The EMD
can also be connected to alarms or indicators and controlled through the iPoMan II 1200. Connect the
EMD to the console port as shown:
If applicable, connect external contact closure inputs to the screw terminals on the EMD. Just like
sensor detector or any device with normally-open or closed.
After connecting to EMD, open a browser from a PC in the network. The temperature and humidity
status is automatically displayed on the PDU Status page.