INK+IVY MILA User manual

Assembly Procedures:
Pre-assembly:
Take out all parts and hardware from box.
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
P2
P1
Item
Parts List
Metal Legs
Table Top
Description
4
1
QTY
Adjustable Levelers 1/4"
H5
H2
Flat Washers 1/4"
Lock Washers 1/4"
Bolts 1/4"x 5/8"L
Allen Wrench
H4
H3
H1
Item Description
Hardware List
4
1
16
16
16
QTY
Step 1: Assemble the table on a flat, soft surface such as a carpet or cloth to prevent
scratching the finish. Assemble Metal Leg (P2) to Metal Leg (P2) as shown below. Do the
same way for two rest Metal Legs.
(H1)x8
(H2)x8
(H3)x8
(H4)x1 Allen Wrench
Bolts 1/4"x 5/8''L
Lock Washers 1/4"
Flat Washers 1/4"
Step 2: Assemble Metal Leg Frames assembled in Step 1 together as shown below.
Attention: Assemble one end first,
then continue with the rest end.
Attention: Assemble one end first,
then continue with the rest end.

(H1)x8
(H2)x8
(H3)x8
(H4)x1 Allen Wrench
Bolts 1/4"x 5/8''L
Lock Washers 1/4"
Flat Washers 1/4"
(H5)x4Adjustable Levelers 1/4"
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE
PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK TO ENSURE THAT ALL
HARDWARE IS KEPT TIGHTENED.
Step 4: Assemble the Adjustable Levelers (H5) as shown below:
Step 3: Attach the assembled Metal Legs (P2) to the table top (P1) as shown below.
Step 5:
a. Turn the table to an upright position.
b. To level table. If there is a gap between a leg and the floor, please adjust the adjustable leveler
up or down under each leg.
c. Assembly is complete.
Thank you for your purchase