INK+IVY Rebecca Queen and King Headboard ii116-0471 User manual

Important safety instructions：
• Please read carefully all instructions before assembling.
• For your safety and ease,assembly by two or more adults is recommended.
• Keep instructions for future use.
Pre-assembly：
• Remove all parts and hardware from box along with any protective packaging.
Parts List
Item
Description QTY
P1
Headboard 1
P2
Left Support Leg with
3 Mounting Brackets
(With the sticker "Left"
on the bottom)
1
P3
Right Support Leg with 3
Mounting Brackets ( With the
sticker "Right" on the
bottom)
1
Hardware List
Item Description QTY
H1 Bolt M8X25mm
5
H2
Spring Washer 5
H3
Flat Washer 5
H4
Allen Key 1
H5
Bolt M8X25mm 4
H6
Spring Washer 4
H7
Flat Washer 4
H8
Nut Cap 4
H9
Solid Wrench 1
Pack A ( Used
to assemble the
headboard )
Pack B
(assemble the
headboard to
the bed frame)
Assembly Procedures:
Step 1.Take out Legs and hardware under the headboard.
DISCLAIMER:
WHEN PROPERLY ASSEMBLED,THIS ITEM IS SAFE FOR INTENDED USE.SELLER IS NOT LIABLE FOR ANY DAMAGES RESULTING FROM
ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
DRAWING
ASSEMBLY INSTRUCTIONS
Description:Rebecca Queen and King Headboard
• Do not discard any content until assembly is completed to avoid accidentally discarding small parts or hardware.
DRAWING

Thank you for your purchase
Page 1 of 1
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE PERIODICALLY
INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY.ALWAYS CHECK TO ENSURE THAT ALL HARDWARE IS KEPT
TIGHTENED.
Step 2.
Put the Headboard onto a flat surface.
Align the mounting position on Headboard
to the mounting position on Left Support
Leg(P2).
Then, lock the top and the middle
mounting positions by Flat washer (H3),
Spring washer(H2), bolt(H1), Then tighten
the bolts with allen wrench (H4) .
Repeat the same steps to install the Right
Support Leg(P3).
At this point of assembly, DO NOT
overfasten the connections.
The final height of the Headboard may be
adjusted to your own need.
Step 3. Headboard is ready to be assembled to bed frame using Pack B Parts.
H1