Inner Balance Wellness Ji User manual

1Chair Manual
Guide d’utilisation

2ibwellness.com
User Manual
Please read this user manual thoroughly prior to operating
the massage chair and keep it for future reference.
inner balance
by
Guide d’utilisation

Contents
Please read and follow all safety and operation instructions listed on this manual
before use. Basic precautions should always be followed when operating the
massage chair.
Safety Instructions.........................................2-3
Product Specications......................................4
Hardware Pack Contents.................................4
Product Components...................................5-6
Chair Installation................................................7
Before Use...........................................................8
Remote Controller.............................................9
Operation Guide............................................. 14
Maintenance.................................................... 15
Trouble Shooting ............................................ 16

ibwellness.com 2
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed,
including the following:
Read all instructions before using this appliance.
DANGER – To reduce the risk of electric shock:
1. Always unplug this appliance from the electrical outlet immediately after using
and before cleaning.
2. Never use pins or other metallic fasteners with this appliance.
3. Carefully examine the covering before each use. Discard the appliance if
the covering shows any sign of deterioration, such as checking, blistering,
or cracking.
4. Keep Dry – Do not operate in a wet or moist condition.
WARNING – To reduce the risk of burns, re, electric shock, or injury
to persons:
1. An appliance should never be left unattended when plugged in. Unplug from
outlet when not in use, and before putting on or taking o parts.
2. Do not operate under blanket or pillow. Excessive heating can occur and
cause re, electric shock, or injury to persons.
3. Close supervision is necessary when this appliance is used by, on, or near
children, invalids, or disabled persons. Keep children away from extended
foot support (or other similar parts).
4. Use this appliance only for its intended use as described in this manual. Do
not use attachments not recommended by the manufacturer.
5. Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the appliance to a service center for examination and repair.
6. Do not carry this appliance by supply cord or use cord as a handle.
7. Keep the cord away from heated surfaces.
8. Never operate the appliance with the air openings blocked. Keep the air
openings free of lint, hair, and the like.
9. Never drop or insert any object into any opening.
10. Do not use outdoors.
11. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
12. To disconnect, turn all controls to the o position, then remove plug
from outlet.

Chair Manual
3
13. Temperatures suciently high to cause burns may occur regardless of
the control setting. Do not use on an infant or invalid or on a sleeping or
unconscious person. Do not use on insensitive skin or on a person with
poor blood circulation. Check the skin in contact with the heated area of the
appliance frequently to reduce the risk of blistering.
14. Do Not Crush – Avoid sharp folds.
15. Connect this appliance to a properly grounded outlet only.
See Grounding Instructions.
16. Do not use massager in close proximity to loose clothing or jewelry.
17. Keep long hair away from massager while in use.
SAVE THESE INSTRUCTIONS
Grounding Instructions
This product must be grounded. If it should malfunction or breakdown,
grounding provides a path of least resistance for electric current to reduce the
risk of electric shock. This product is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance with all
local codes and ordinances.
DANGER – Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check with a qualied electrician
or serviceman if you are in doubt as to whether the product is properly
grounded. Do not modify the plug provided with the product – if it will not t the
outlet, have a proper outlet installed by a qualied electrician.
This product is for use on a nominal 120-V circuit, and has a grounding plug
that looks like the plug illustrated in sketch A in follow Figure. A temporary
adapter that looks like the adapter illustrated in sketches B and C may be
used to connect this plug to a 2-pole receptacle as shown in sketch B if a
properly grounded outlet is not available. The temporary adapter should be
used only until a properly grounded outlet (sketch A) can be installed by a
qualied electrician. The green colored rigid ear, lug, or the like extending from
the adapter must be connected to a permanent ground such as a properly
grounded outlet box cover. Whenever the adapter is used, it must be held in
place by a metal screw.
GROUNDING METHODS
Grounded
Outlet Box
Metal
Screw
Adapter
Tab for
Grounding Screw
Grounding
Pin
Grounded
Outlet

ibwellness.com 4
Product Specications
Description Specications
Product Name Massage Chair
Model No. Ji
Rated Voltage AC110V
Rated Frequency 60Hz
Rated Power
Consumption 230W Max.
Dimension (LxWxH) 57 (L) x 31.5 (W) x 46 (H) in
Weight Net Weight: 198.5lb Gross Weight: 236lb
Hardware Pack Contents
-1 power cord
-1 M6 Allen wrench
- 6 M6*20 shoulder xed screws

Chair Manual
5
Product Components
MAIN BODY DIAGRAM (FRONT)
Pillow Cushion
Arm Airbags
Seat Cushion
Legrest
Footrest
Wheels
Backrest Cushion
Side Panel
Shoulder Airbags
Shortcut keys

ibwellness.com 6
Product Components
MAIN BODY DIAGRAM (FRONT)
Product Components
MAIN BODY DIAGRAM (REAR)
Main Power Switch
Safety Fuse
Power Cord Socket

Chair Manual
7
Chair Installation
1. Removing the chair and parts from the package
Lift Carton Upwards
Lift Carton Upwards
a. Lift and remove main outer carton.
b. Remove cardboard and foam on both sides of the massage chair.
c. Remove accessory box (includes: instructions, power cord etc.).
2. Finding a location for the chair
3. Moving the massage chair
Allow sucient space around the chair
for recline purposes. (6in distance for the
back side and 20in in front of
the footrest.)
* To avoid damage to the oor and reduce
the noise, put an area rug under the
massage chair.
* Please do not put it on wet or
uneven oor.
* To avoid signal interference, please place it 4
feet away from AV, TV, and radio.
Push backrest downwards to tilt the chair at
a 45’ angle. Slowly maneuver the chair to a
desired location. Lower the chair slowly and
smoothly until it is fully at on the ground.
* Do not move massage chair when in use.
* Moving the massage chair may cause damage to
oors. Floor protection is recommended
(e.g. rugs, carpet).
* Do not drop or suddenly let go of the chair when
moving as it may damage the chair.
* It is recommended to work with at least
two people.
6in 20in

ibwellness.com 8
4. Adjust the position of the headrest.
– Adjust the under-part of the
headrest and align it with the
position of the ear.
1. Make sure that the product is in
good condition.
– Conrm that the headrest, backrest
and power plug are not damaged.
– Make sure the footrest is in its right
position (as shown in the diagram to
the left).
2. Check the surrounding area to make
sure that it is clear of any obstruction
for incline and recline of the chair.
– Make sure there are at least 6in back
and 20in in front of the chair.
3. Connect the chair to a power source.
– Plug the chair in.
– Turn the power switch to “on.”
Before Use

Chair Manual
9
Remote Controller
Boost
Pro
Therapy
PRE-PROGRAMMED
AUTO COURSES
PRE-PROGRAMMED
AUTO COURSES
MANUAL
CONTROLS
Width
Rollers Up
Whole
Point
Pause
Rollers Down
Air
Roller
Display
Stretch
Vigor
Yoga
MANUAL
CONTROLS
INCLINE
AND RECLINE
BUTTONS
Legrest
Up
Zero
Gravity
INCLINE
AND RECLINE
BUTTONS
Backrest
Up
Legrest
Down
Backrest
Down
Speed
Air
Intensity
Heat
Time
ACTION
KEYS
ACTION
KEYS
On/o

ibwellness.com
Operation Guide
SHORTCUT KEY FUNCTION CHART (LEFT SIDE PANEL)
Backrest
Up
Legrest
Down
Backrest
Down
10
Backrest position up
Legrest position up
On/o
Legrest position down
Backrest position down

Chair Manual
11
Operation Guide
DISPLAY DIAGRAM
1. Power is on
2. Massage chair is scanning the users back contour
3. Scanning is complete and the massage is about to begin
4. Pause button has been pressed and the chair is temporarily stopped
5. Reclining position adjustment buttons are pressed and the backrest and/or
legrest are moving
6. Which massage technique is activated
7. Direction of massage rollers
8. Speed level
9. Air intensity level
10. Massage roller width
11. Heating function is on
12. Location of massage rollers and active air bags
13. Time remaining in current massage program
14. An Auto Course is activated
1 2 3 4
10 9 8
5
6
7
14
13
12
11

ibwellness.com 12
12
Operation Guide
FUNCTION DESCRIPTION OF CONTROLLER BUTTONS
Power Button
Press the power button to turn ON the massage chair. Press again to
turn OFF. Massage chair will then return to default upright position.
Position Adjustment Buttons
Press this button to move the back and leg position. Press once for
Zero G1, twice for Zero G2, three times for Zero G3 and four times to
return to the original position.
Press and hold this button to adjust the footrest.
Press and hold this button to adjust position of
the backrest or legrest.
Note: The position adjustment buttons are disabled when the chair is in
STRETCH mode.
Heat – Press to turn heating function on
and o.
Speed – Press to cycle through three levels
of speed: Tapping & Kneading, Dual Action
& Shiatsu.
Intensity – Press to cycle through ve levels
of intensity.
Time – Press to increase the massage time in
increments of 5 minutes. The default working
time is 15 minutes. The maximum working time
is 30 minutes.
Zero G1 "Zero G2 "Zero G3 "Original Position

Chair Manual
13
Operation Guide
FUNCTION DESCRIPTION OF CONTROLLER BUTTONS
AUTO COURSES
This chair is designed with 6 auto
massage modes: PRO • BOOST •
VIGOR • THERAPY • STRETCH • YOGA
MANUAL CONTROLS
Width: Press once to adjust the width of the rollers.
Roller Location: Press and hold the up or down arrows to move the
massage rollers to the desired location.
Pause: Press once to temporarily pause or stop all the massage
functions. Chair will enter idle mode. Press again to resume massage
Whole: Press to manually choose the technique massaging the
whole back.
Air: Press this button for dierent combinations of massage.
Point: Press to control the location of the massage roller, once
pressed use the up and down arrows to position the rollers.
Roller: Press to activate the foot roller in the bottom of the
foot massager

ibwellness.com 14
Operation Guide
USING THE BLUETOOTH SPEAKER
1. After the massage program is completed,
return chair to upright position by pressing
the On/O button. Before pressing:
- Make sure surrounding area is clear.
- Keep arms and legs away from gaps
between the armrest, legrest, and
footrest, to prevent possible injury.
2. Return remote controller to the storage
pocket in the front of the chair by the
users knee.
3. Turn o the main power switch.
4. Remove plug from power outlet.
- Do not pull on the power cord to remove
the plug.
- Do not unplug with wet hands.
Open the bluetooth function in your device and search nearby. Choose the
massage chair bluetooth and connect. The password is 0000 (or 1234).
AFTER USE

Chair Manual
15
Maintenance
- Turn o and unplug the chair
before cleaning.
- Use a dry, neutral colored cloth or
soft bristled brush to lightly wipe
the chair.
- Do not use water or any other
liquids to clean the chair.
- It must be sure storage of the cord
and the product in dry place to avoid
damage to the product.
Any other servicing should be performed by an
authorized service representative.

ibwellness.com 16
Trouble Shooting
PROBLEM SOLUTION
The massage chair is connected to
power but is not functioning.
1. Check if the power plug is inserted
properly and the power outlet is
functioning properly.
2. Check to see if the main power switch is
in the “on” (“ I ”) position.
The remote controller is responding,
but the massage chair is not
functioning.
The massage chair may have automatically
shut down to prevent overheating. Please
turn o the power and allow the chair to
cool for 30-50 minutes.
Neither the remote controller or
massage chair are responding.
The massage chair automatically goes into
“full stop” or “idle” mode when a massage
program is completed. Please press the
power button again to turn on the chair.
.
If the sounds or movements are not normal, turn OFF the massage chair and
remove the power cord from the electric outlet. Contact the customer service
department for further assistance.

19 Chair Manual
User Manual - English

20ibwellness.com
inner balance
by
par
Guide d’utilisation
Veuillez lire ce guide en entier avant d’utiliser le fauteuil
de massage et conservez-le pour référence future.
User Manual - English