Inseego SKYUS 160 Series User manual

Quick Start Guide
This guide provides instructions for configuring and connecting your Skyus 160.
Step one: connect antennas
Antenna Ports Frequency Range Connector Type
1. CELL 1 690–960 MHz; 1700–2700 MHz SMA
2. GPS** 1570 - 1580 MHz SMA
3. CELL 2 690–960 MHz; 1700–2700 MHz SMA
SKYUS 160
123
Finger tighten your antennas onto the threaded antenna ports*. NOTE: At a minimum,
be sure to connect antennas to CELL 1 and CELL 2. The device will not work without cell
antennas connected.
* Recommended torque is 5 in-lbs.
** Ensure GPS antenna is located with clear access to GNSS satellites.
Back of device
Battery tray
Reset button*
SIM 1 IN SIM 2 IN
* To reset the device, press and release the reset button. To restore to factory default
settings, press and hold for 15 seconds.

MKT-00019 Rev 6 ©2023 Inseego Corp. All rights reserved.
Navigation
Device Cellular
ON/EXTERNAL POWER
ON/BATTERY POWER (HIGH)
ON/BATTERY POWER (LOW)
ON/BATTERY POWER (CRITICAL)
ERROR WHEN BLINKING
GREAT SIGNAL
GOOD SIGNAL
OK SIGNAL
POOR SIGNAL
NO SIM/
INACTIVE SIM
ERROR
Wi-Fi ON - CONNECTED CLIENTS
WI-FI ON - NO CLIENTS
BLUETOOTH ON - CONNECTED CLIENTS
Wi-Fi AND BLUETOOTH ARE BOTH ON
ERROR
Wi-Fi/BLUETOOTH OFF
SIGNAL ACQUIRED
ACQUIRING
ERROR
GPS OFF
Wi-Fi/Bluetooth
Support and more
My Verizon mobile app
Manage your account, track your usage, edit account information, pay your bill and more.
Get help using your Skyus 160
Using any Wi-Fi enabled device and an Internet browser.
From your computer, visit verizonwireless.com/Support.
Customer service
Call 800.922.0204
Twitter @VZWSupport.
More information
To access a User Guide, go to verizonwireless.com/Support and find your device.
Step three: use your device
After the device has been connected and powered up for at least 10 mins, you can verify
connectivity by opening up an internet browser and confirming that you can reach a web page.
LED reference
Step two: power on and connect your device
Power the device via 4-pin, Ethernet, or USB port and connect to a PC using Ethernet, USB
or Wi-Fi. To allow the Skyus adequate time to provision with your service provider, leave it
on for at least 10 mins when the device is first connected with a new SIM.
Power Button
USB Device Port
(power and/or data)
Ethernet LAN
(power and/or data)
4-pin Latching
Connector
(power and GPIO)
Step four: set up Inseego Connect
Go to connect.inseego.com to sign up for a free Inseego Connect account that lets you
configure settings, monitor status, and update the firmware on your device. Additional
functionality can be obtained with a subscription to Inseego Connect Standard or
Advanced.