InStep Elite ET100 User manual

1
Keep this manual for future reference. If you sell or give this
stroller away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
Elite ET100 STROLLER
Elite Operating Instructions
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you
have any questions concerning the safe use of this product, contact InSTEP LLC at 1-800-242-6110, M-F,
8:00 a.m. - 5:00 p.m. CST or visit our web site at www.instep.net or e-mail us at [email protected] before using.
Safety Rules:
WARNING: Failure to follow these warnings and assembly instructions could result in
serious injury or death.
WARNING: Immediately discard any plastic wrapping.
WARNING: Never allow children to fold, assemble or disassemble the stroller.
WARNING:
Do not use stroller until your child is old enough to hold his/her head up on his/her own.
WARNING: Maximum weight capacity for a child in this stroller is 50 lbs. or 22.7 kg.
WARNING: Never place child in stroller on their back with their head forward and feet rearward.
WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt.
WARNING: Never leave child unattended.
WARNING: Never use this stroller with roller skates or in-line skates.
WARNING: Never allow this stroller to be used as a toy or allow children to give rides to others.
WARNING: Never use stroller if it becomes damaged.
WARNING: Always be aware of traffic around you when walking or jogging.
WARNING: Always apply brakes when you stop or when you let go of handle.
WARNING: Always use an approved bicycle helmet on child.
WARNING: Always use wrist strap.
WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.
WARNING: Maximum weight for objects in back pouch is 2.2 lbs. or 1 kg. Excessive weight may cause
a hazardous unstable condition.
WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position
unless T-shield and shoulder strap placement has been re-adjusted to the seat’s new position.

2
IMPORTANT
Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 20-25 PSI
maximum. 25 PSI will provide a comfortable ride for your child.
We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with
your selection. We regret that although great care and effort have been taken, occasionally problems may
occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of
problems, or to answer questions, please contact us at either our Toll-Free Customer Service Number or e-
mail us at our number listed below. Service will be quicker if you have your model number (found on the
product and box) along with this instruction sheet ready when calling. If you have any questions concerning
the safe use of this product, Please contact us 1-800-242-6110 press “1” for customer service and then “2 “to
speak to a representative or e-mail us at [email protected] or visit our web site at www.instep.net.
Elite Assembly Instructions Model No. 11-ET100
Parts List
Description Qty.
Frame Assembly w/seat, canopy, basket and wrist strap 1
Front Wheel Assembly with quick release axle 1
Rear Wheel Assembly with quick release axles 2
Stroller Assembly Instructions
Step 1. Unfold Stroller
Grasp handle with one hand, and pull up on the
front fork with your other hand. Lock both plastic
latches onto the lower frame (Figure A).
Step 2. Rear Wheel Assembly
Turn stroller onto it’s side, push in the black
button on the center of the hub and insert axle
into the hole in the rear frame. Pull on wheel to
ensure it is locked in place. Repeat for other side
(Figure B). To remove wheel push in black button
on hub and pull off wheel.
A
B
Latches
Lower
Frame
Front Fork
Rear Frame
Handle
Rear Frame
Rear Wheel
Push in black
button to insert
and remove
wheel

3
Step 3. Front Wheel Assembly
Turn stroller upright onto its rear wheels and then
tip stroller back so that the handlebar is down on
the ground and the front fork is up. The front
brake Quick Release lever (Q/R), located on the
front fender, should be in the open position
(Figure C).
Attach the front wheel by loosening the wheel’s
quick release (Q/R) lever on the front wheel far
enough to allow the axle to slide into the front
fork (Figure D). With lever in open position, hand
tighten the cone nut until almost tight, then flip
lever backward to the closed position to lock
wheel in place. Note this step may require minor
adjustment until the Q/R lever flips back with firm
pressure (Figure E). Pull outward on wheel to
ensure it is locked in place.
Close the front caliper brake by lowering the Q/R
lever (Figure F). Spin the front wheel to make
sure the brake pads do not rub and are properly
aligned to the rim. If brake pad alignment is off,
loosen brake pad nut with an adjustable wrench,
align brake pad and retighten nut while holding
the brake pad in place.
WARNING: The interior jam nuts are
factory installed and do not need adjustment.
WARNING: Always be sure to re-engage
the brake by rotating the Q/R lever forward
(toward the front wheel) before using the stroller.
Assembly is now complete!
C
D
E
F
Brake Pad
Nut
Brake Pads
Closed
Open
Q/R Brake
Lever
Q/R Lever
Open
Q/R Lever
Closed
Closed
Cone
Nut
Cone
Nut
Front Fork
Adjusting
Sleeve Lock Ring
Q/R Brake
Lever Closed
Brake Pad Nut

4
Use Instructions
To close/ fold stroller:
WARNING: Always remove child from
stroller before folding.
Push canopy back and pull the seat back
forward. Flip the latches from the lower bar.
Push down on the handle, the stroller will
automatically begin to fold, the front wheel will
fold under frame and the handle will fold
downward (Figure F).
To open stroller:
Grasp handle with one hand and pull up on the
front axle mount with your other hand. Lock both
plastic latches onto the lower frame (Figure G).
To engage rear brakes:
Step lightly on the levers next to the rear wheels
until the cogs of the brakes engage the cogs of
the wheel. Repeat on other side. To release
brake, lift levers with toe until cogs disengage
(Figure H).
To operate front caliper brake:
The front brake operates the same as a bicycle
hand brake. Squeeze lever located on handlebar
to engage front brake. Release lever to
disengage. To engage parking brake, squeeze
lever and push down lock button. To disengage
lock squeeze lever again (Figure I).
WARNING: Whenever child is in stroller
always use the wrist strap. Before you remove
the wrist strap from your wrist make sure you first
engage the rear brakes or the front brake.
G
H
I
F
Adjusting
Sleeve Lock Ring
Q/R Brake
Lever Closed
Front Fork
Canopy
Latches
Handle
Pull Seat Forward to Fold
Rear Brake Lever
Front Brake Lever
Lock Button

5
J
K
PROPER USE OF SEAT BELTS &
SHOULDER STRAPS:
WARNING: Avoid Serious Injury. Always
use seat belts
1. Place child in seat. Make sure T-Shield is
between the child’s legs
2. When child is seated, place shoulder straps
over the child’s shoulders.
3. Bring lap belt ends around child’s waist and
clip into the T-Shield buckle. Adjust straps for
snug fit.
4. Adjust length of shoulder straps for a proper fit
(Figure J).
WARNING: Always adjust lap belt so that
the lap belt is securely around child’s waist.
To recline seat:
• To fully recline, unhook buckle on rear section
of seat back (Figure K).
• To place seat in upright position, push seat
forward and reconnect buckle located on rear of
seat back.
• To adjust the upright position, adjust the slides
on the rear straps.
WARNING: Child may slip into leg
openings and strangle. Never use in a reclined
carriage position unless T-shield and shoulder
strap placement has been re-adjusted to the
seat’s new position.
Shoulder Strap
Adjustment Slides
Shoulder Strap
T-Shield
Lap Belt
Shoulder Strap
Flap to Remove
Reinforcements
Recline
Adjustment
Slide
Recline
Adjustment Slide
Recline Buckle
Rear Seat
Pouch

6
Care and Maintenance
Check fasteners
After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary.
Periodically check the stroller to ensure that it is in good operating condition.
To adjust the stroller from veering - not rolling straight:
Open the front Q/R lever, point the front wheel forward or in the opposite direction the stroller is
veering, then close Q/R lever. Repeat if necessary.
To adjust front brake caliper:
For micro adjustment, turn the front brake caliper’s adjusting sleeve. Once the brake pads are
adjusted to the desired distance from the rim, tighten the lock ring. Periodically you will need to
adjust the cable since it is normal for the cable to stretch from use (see Figure F, page 4).
To clean seat and canopy:
If light cleaning is required, use a soft cloth with warm water and mild soap then air dry. If heavily
soiled, remove plastic reinforcements from the backrest and unsnap seat and canopy from frame.
Make sure you make note on how the seat and canopy are assembled onto the frame. Place seat
and canopy in washing machine on GENTLE cycle. Replace reinforcements and snap seat and
canopy back onto stroller and allow to air dry. Do not put in dryer. DO NOT BLEACH.
To clean frame:
Wipe using a soft cloth with warm water and mild soap. Air dry. DO NOT USE polish or harsh
abrasives.
**WARNING: If you have any questions concerning the safe use of this product, please
contact InSTEP LLC before using.
1-800-242-6110
8am-5pm CST, Monday-Friday, or MAIL to:
314West 86th Street
Bloomington, MN 55420
Tel: [phone]
or visit our web site at www.instep.net
email: [email protected]