InStep SB100 User manual

1
Keep this manual for future reference. If you sell or give this
stroller away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
STROLLER/FRAME CARRIER
SB100 Operating Instructions
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller/frame
carrier. If you have any questions concerning the safe use of this product, contact InSTEP, LLC at
1-800-242-6110, M-F, 8:00 a.m. - 5:00 p.m. CST or visit our web site at www.instep.net or E-mail us at
[email protected] before using.
Safety Rules:
WARNING: Failure to follow these warnings and assembly instructions could result in
serious injury or death.
WARNING: Immediately discard any plastic wrapping.
WARNING: Never allow children to fold, assemble or disassemble the stroller/frame carrier.
WARNING: Do not use stroller/frame carrier until your child is old enough to hold his/her head up on
his/her own.
WARNING: Maximum weight capacity for a child in this stroller/frame carrier is 30 lbs. or 14 kg.
WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt and shoulder harness.
WARNING: Never leave child unattended.
WARNING: Never use this stroller/frame carrier with roller skates or in-line skates.
WARNING: Never allow stroller/frame carrier to be used as a toy or allow children to give rides
to others.
WARNING: Never use if product becomes damaged.
WARNING: Always be aware of traffic around you when walking
WARNING: Always engage brakes when you stop or when you let go of handle.
WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.
WARNING: Maximum weight for objects in back pouch is 1 lb. or .5 kg., bottom basket is 2.2 lbs.
or 1 kg. Excessive weight may cause a hazardous unstable condition.
WARNING: For child’s safety it is best to have another adult help you put on the carrier while child
is in it. Make sure the child is securely strapped in with both shoulder straps and waist
straps prior to putting on the carrier.

2
IMPORTANT
We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with
your selection. We regret that although great care and effort have been taken, occasionally problems may
occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of
problems, or to answer questions, please contact us at either our Toll-Free Customer service Number or
Email us at our number listed below. Service will be quicker if you have your model number (found on the
product and box) along with this instruction sheet ready when calling. If you have any questions concerning
the safe use of this product, Please contact us 1-800-242-6110 press “1” for customer service and then “2 “to
speak to a representative or E-mail us at [email protected] or visit our web site at www.instep.net
SB100 Assembly Instructions
Parts List
Description Qty.
Frame assembly with seat, belly bar and headrest 1
Canopy 1
Dual Front wheel assemblies with booties 2
Rear wheel axle assembly 1
Stroller Assembly Instructions
Step 1. Unfold Stroller
Push in the handle buttons located on each side of
the stroller (Picture A). While holding buttons, grasp
handle on each side, lift up so stroller raises off the
ground. Shake gently - the stroller will automatically
unfold. Continue extending handle until the handle
buttons snap into place.
Lift up on the front belly bar until it snaps into place
(Picture B). To lower belly bar for storage, push in
the latches located on each side of the belly bar
(under the material) and then push belly bar down
(Picture C). Return belly bar to upright position so it
snaps in place.
A
CB
Frame
Assembly
Rear
Wheel Axle
Front
Wheels
w/Booties
Canopy
Belly Bar
(down
position)
Belly Bar
Latches (under
material
Handle
Buttons
Rear Leg
Front
Leg
Belly
Bar
Back
Rest
Up
Down
Belly
Bar
Latches
Belly Bar
Latches
(under
material)

3
Step 2. Rear Wheel Axle Assembly
Tip stroller so the belly bar is on the ground and
the rear legs are up. Hold the axle with the
brake levers up. Align the wheel brackets with
the legs and push on wheel bracket until they
lock into place on both sides (Picture D). Pull
on wheels to make sure they are locked in
place. In the future, if you need to remove rear
axle, push tab that is located inside the wheel
brackets and pull each side off (Picture E).
Step 3. Front Wheel Assembly
Turn stroller on its side. Slide the front wheel
assembly onto the front fork and push until it
locks in place (Picture F). Pull on wheel to make
sure that it is locked in place. Repeat for other
side. In the future, if you need to remove front
wheels, push tab that is located on bottom of
wheel assembly and pull off (Picture G).
Note: There is a lever on the wheel assembly
that locks the wheels from swiveling when used
as a frame carrier.
Step 4. Canopy Assembly
Turn stroller upright. Place the canopy so the
rounded edge is positioned behind the headrest
and snap it onto the back of headrest. Bend the
canopy and snap both sides onto the belly bar
(Picture H).
Congratulations - assembly is now complete!
E
G
F
H
Rear Brake Lever
Rear
Wheel
Dual Front
Wheel
Swivel Lock
Lever
Front Leg
Front Wheel
Swivel
Lock
Lever
Front
Wheel
Removal
Tab
Tab for Rear
Wheel Removal
Rear
Canopy
Snap
Belly
Bar
Snap
Waist
Strap
Cover
DRear Wheel
Axle Assembly
Notch in
Leg Up
Notch
Rear
Legs
Rear
Brake
Levers

4
Use Instructions
To close stroller:
While pushing in the handle buttons, grasp the
handle tubes and push the handle in. The stroller
will fold as handle is pushed in (Picture I)
To open stroller:
Push in the handle buttons located on each side of
the stroller. While holding buttons, grasp handle on
each side, lift up so stroller raises off the ground.
Shake gently - the stroller will automatically unfold.
Continue extending handle until the handle buttons
snap into place.
To engage rear brakes:
Step lightly on the levers next to the rear wheels
until the cogs of the brakes engage the cogs of the
wheel. Repeat on other side. To release brake, lift
levers with toe until cogs disengage. (Picture J)
PROPER USE OF SEAT HEIGHT
ADJUSTMENT, CROTCH STRAP
& SHOULDER STRAP:
WARNING: Avoid Serious Injury from falling
or sliding out. Always use seat
belts
1. Place child in seat. Adjust the seat height by
pulling or loosening straps located on the sides
(Picture K). Make sure crotch strap buckle is
between the child’s legs, adjust length by
sliding strap through plastic slide (Picture L).
2. Place shoulder straps over child’s shoulders
and buckle into center crotch buckle. Adjust
shoulder straps to a snug fit by sliding strap
through plastic slide (Picture L).
3. Buckle waist strap around child’s waist and
adjust to a snug fit (Picture L)
I
J
Handle
Buttons
Rear
Brake
Levers
Bottom
Basket Rear
Wheel
Rear Brake Levers
K
L
Back Rest
Shoulder
Strap Handle
Seat Height
Adjustment
Strap
Belly Bar
Seat
Shoulder
Straps
Crotch Buckle
Waist Strap
Seat Straps
Crotch Strap

5
To convert stroller to
a frame carrier
WARNING: Please request the help of
another adult to help you put
the frame carrier on.
1. With rear wheels locked, release the
Frame carrier waist strap cover located
between the front legs (Picture M).
2. Push the lever up on the front wheels to
lock them from swiveling. Tilt the stroller
back slightly, and slide the booties onto the
front wheels. This will prevent your clothes
being soiled by the wheels (Picture M).
3. Release the waist buckle and sternum
(chest) buckle (Picture N).
4. To close the stroller, step behind the
stroller, then push the handle buttons
located on the sides of the stroller frame.
5. With the help of another adult to steady
the child in the seat, stand in front of the
stroller. Place one arm through the shoul-
der strap and lift stroller onto your shoul-
der/back. You will find this much easier if
the other adult also assists you with hold-
ing the other shoulder strap and guiding it
over your other shoulder.
6. Once both shoulder straps are on, pull
down on the shoulder strap ends to tight-
en. This will position the child higher onto
your shoulders (Picture O).
7. Adjust the height of the sternum straps by
sliding them up or down. Buckle the
sternum strap then pull the end of the
sternum strap to tighten (Picture P).
8. Buckle the waist strap and pull end of the
waist strap to tighten (Picture Q).
M
Waist Strap Cover
Swivel
Lock
Lever
Front
Wheel
Booties
N
O
Sternum
Strap
Buckle
Waist Buckle
Shoulder
Straps
Sternum Stap
Adjusts Up or
Down
Waist
Belt
Buckle
Shoulder Strap
End
PQ
Sternum
Buckle Waist
Buckle
Waist Strap
Sternum
Strap
Adjusing
Slide

6
Care and Maintenance
Check fasteners
After one hour of use, check all fasteners to make
sure they are secure. Adjust if necessary.
Periodically check the stroller to ensure that it is in
good operating condition.
To clean seat:
If cleaning is required, use a soft cloth with warm
water and mild soap; air dry. DO NOT BLEACH.
To clean canopy:
Spot clean using a soft cloth with warm water and
mild soap. DO NOT BLEACH. Do not put in a
washing machine.
To clean frame:
Wipe using a soft cloth with warm water and mild
soap. Air dry. DO NOT USE polish or harsh abra-
sives.
**WARNING: If you have any questions concerning the safe use of this product, please con-
tact InSTEP LLC. before using.
1-800-242-6110
8am-5pm CST, Monday-Friday, or MAIL to:
2425 Enterprise Drive, Suite #900
Mendota Heights, MN 55120
Tel: [phone]
or visit our web site at www.instep.net
email: [email protected]