Intex TL520 User manual

(137PO) SPA TRAY WITH LED LIGHT ENGLISH SIZE: 4.875” X 7.25” 06/22/2020
English 137
PO
SAVE THESE INSTRUCTIONS
Page 1
INTEX®OWNER'S MANUAL
SPA TRAY WITH LED LIGHT
Model
TL520
0.2 W
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
• For adult use only. This product is not a toy, keep away from children.
• Do not stare directly at the light emitted by this product.
• Do not replace the batteries while in the pool or spa.
• Do not sit, straddle or stand on the product.
• Never place hot liquids, glass or breakable objects on the product.
• Remove product before placing a cover over the spa tub.
• Do not dispose of the batteries in regular trash, municipal waste stream or by fire as
battery may leak or explode. Always dispose of the batteries safely in accordance with
your local law and regulations.
• Never recharge non-rechargeable batteries.
• Do not short-circuit the terminals of the battery or rechargeable battery.
• This product is resistant to water, but it is not designed to be completely submerged.
Submersion could cause water to enter the product causing damage to the electronics.
FOLLOW THESE RULES AND ALL INSTRUCTIONS TO AVOID INJURY
OR PROPERTY DAMAGE.
WARNING
137-*PO-R0-2106
General Information:
•This product operates on two (2) replaceable CR2032 size lithium
batteries.
• Do not mix old and new batteries. Do not mix alkaline, standard
(Carbon - Zinc), or rechargeable (Nickel - Cadmium) batteries.
• Dry any water on the product prior to battery installation. Remove used
batteries promptly. Replace all the batteries at the same time.
• Always purchase the correct size and grade of battery most suitable
for the intended use. Ensure batteries are installed correctly with
regard to polarity (+ and -). Clean the battery contacts and also those
of the device prior to battery installation.
• To clean the product, use only a damp cloth. Avoid strong cleaner,
excessive water and abrasive brush.
• If leaking battery liquid (electrolyte) comes in contact with skin, wash
immediately with soap and water or neutralize it with vinegar or lemon
juice. In case of contact with eyes, rinse immediately with plenty of
water for 10 minutes and seek medical advice.
• The light source of this appliance is not replaceable; when the light
source reaches its end of life the whole appliance shall be replaced.
• Store the product indoors when not in use.

(137PO) SPA TRAY WITH LED LIGHT ENGLISH SIZE: 4.875” X 7.25” 06/22/2020
English 137
PO
SAVE THESE INSTRUCTIONS
Page 2
Parts Reference:
3
2
1
REF. NO. DESCRIPTION QTY. SPARE PART NO.
1 Switch & battery cover 1 13024
2 Seal 1 13025
3 SPA tray with LED light 1 13026
Note: Drawings for illustration purposes only. Actual
product may vary. Not to scale.
To Install or Replace the Batteries:
1. While pushing down the “child lock” rotates the switch & battery cap (1)
fully counterclockwise and remove it from the tray. See Fig (1).
2. Remove the old batteries from the switch & battery cap (1), see Fig (2) and
insert 2 new CR2032 batteries following the orientation shown in Fig (3). Make
sure the seal (2) is in place.
3. Reinstall the switch & battery cap (1) to the spa tray.
1
child
lock
23
Setup and LED Light Operation:
1. Unfold the arms. See Fig (4).
2. Place the spa tray over a spa wall top edge. Ensure the arms are snugly fitted
over the wall and the spa tray is parallel to the level ground. See Fig (5). You
may place a tablet or smartphone on the groove. NOTE: Not suitable for
SimpleSpaTM model.
3. Rotate the switch & battery cap (1) clockwise to turn ON the light, and rotate
counterclockwise to turn OFF the light. See Fig (6).
45 6
Storage:
1. Clean and air dry thoroughly.
2. The original packaging can be used for storage. Store in a dry, cool storage
location.

(137PO) SPA TRAY WITH LED LIGHT ENGLISH SIZE: 4.875” X 7.25” 06/22/2020
English 137
PO
SAVE THESE INSTRUCTIONS
Page 3
Limited Warranty
Your SPA TRAY WITH LED LIGHT has been manufactured using the highest quality
materials and workmanship. All Intex products have been inspected and found free of defects
prior to leaving the factory. This Limited Warranty applies only to the SPA TRAY WITH LED
LIGHT.
The provisions of this Limited Warranty apply only to the original purchaser and is not
transferable. This Limited Warranty is valid for a period of one (1) year from the date of the
initial retail purchase. Keep your original sales receipt with this manual, as proof of purchase
will be required and must accompany warranty claims or the Limited Warranty is invalid.
If a manufacturing defect is found within this one (1) year period, please contact the
appropriate Intex Service Center listed in the separate “Authorized Service Centers” sheet.
The Service Center will determine the validity of the claim. If the Service Center directs you to
return the product, please carefully package the product and send with shipping and insurance
prepaid to the Service Center. Upon receipt of the returned product, the Intex Service Center
will inspect the item and determine the validity of the claim. If the provisions of this warranty
cover the item, the item will be repaired or replaced at no charge.
Any and all disputes regarding the provisions of this Limited Warranty shall be brought before
an informal dispute settlement board and unless and until the provisions of these paragraphs
are carried forth, no civil action may be instituted. The methods and procedures of this
settlement board shall be subject to the rules and regulations set forth by the Federal Trade
Commission (F.T.C.). IMPLIED WARRANTIES ARE LIMITED TO THE TERMS OF THIS
WARRANTY AND IN NO EVENT SHALL INTEX, THEIR AUTHORIZED AGENTS OR
EMPLOYEES BE LIABLE TO THE BUYER OR ANY OTHER PARTY FOR DIRECT OR
CONSEQUENTIAL DAMAGES OR LIABILITIES. Some states, or jurisdictions do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
This Limited Warranty does not apply if the product is subject to negligence, abnormal use
or operation, accident, improper operation, improper voltage or current contrary to operating
instructions, or to damage by circumstances beyond Intex’s control, including but not limited
to, ordinary wear and tear and damage caused by exposure to fire, flood, freezing, rain, or
other external environmental forces. This Limited Warranty applies only to those parts and
components sold by Intex. The Limited Warranty does not cover unauthorized alterations,
repairs or disassembly by anyone other than Intex Service Center personnel.
DO NOT GO BACK TO THE PLACE OF PURCHASE FOR RETURN OR REPLACEMENT.
IF YOU ARE MISSING PARTS OR NEED ASSISTANCE, PLEASE CALL US TOLL-FREE
(FOR U.S. AND CANADIAN RESIDENTS): 1-800-234-6839.
Proof of Purchase must accompany all returns or the warranty claim will be invalid.
©2020 Intex Marketing Ltd. - Intex Development Co. Ltd. - Intex Recreation Corp.
All rights reserved/Tous droits réservés/Todos los derechos reservados/Alle Rechte vorbehalten.
Printed in China/Imprimé en Chine/Impreso en China/Gedruckt in China.
®™ Trademarks used in some countries of the world under license from/®™ Marques utilisées dans certains
pays sous licence de/Marcas registradas utilizadas en algunos países del mundo bajo licencia de/Warenzeichen
verwendet in einigen Ländern der Welt in Lizenz von/Intex Marketing Ltd. to/à/a/an Intex Development Co.
Ltd., G.P.O Box 28829, Hong Kong & Intex Recreation Corp., P.O. Box 1440, Long Beach, CA 90801
•DistributedintheEuropeanUnionby/Distribuédansl’UnionEuropéennepar/DistribuidoenlauniónEuropea
por/Vertrieb in der Europäischen Union durch/Intex Trading B.V., Venneveld 9, 4705 RR Roosendaal – The
Netherlands
www.intexcorp.com
Table of contents
Other Intex Spa Accessories manuals
Popular Spa Accessories manuals by other brands

Strategic Scents
Strategic Scents Shopfront Setup guide

Leisure Concepts
Leisure Concepts Covermate III installation instructions

Sonia
Sonia Limb Warm user manual

Spin Spa
Spin Spa Spinning Spa Brush quick start guide

Takara Belmont
Takara Belmont YUME NAGOMI installation instructions

Leisure Concepts
Leisure Concepts Covermate III instructions