ipf electronic IB05010H User manual

MANUAL - Subject to alteration! Version: October 2017
ipf electronic gmbh │ Rosmarter Allee 14 - 58762 Altena - Germany │ Tel [phone] - [e-mail] -
www.ipf-electronic.com 1
IB05010H
IB05017H
O erating range semi-flush 2.5mm
I Nickel ilver hou ing
I Built-in amplifier
I LED di play
I Very large witching di tance
I Short-circuit proof and rever e polarity protected
Technical data
Current consum tion  10mA
Voltage dro (max. load)  2.0V
O erating voltage U
B
10 ... 30V DC
Switching out ut n , no, max. 200mA
Nominal switching distance 2.5mm
Standard measuring late 7.5 x 7.5 x 1 mm
Switching hysteresis< 8%
Re eatability 0.03mm (U=24V diagnostic coverage , T=23°C±5°C)
max. switching frequency 800Hz
Dis lay (switching state) LED yellow
Protection class IP 67 (EN 60529)
Ambient tem erature -25°C to +70°C
Connection see article list
Reduction factors Steel : 1.0 V2A: 0.67 Ms: 0,42
Cu: 0,30 Aluminum: 0.33
Connection Re pon e curve
Color : 1 = BN (brown)
4 = BK (black)
3 = BU (blue)
Function : 1 = L+, 4 = PNP NO, 3 = L-
Article li t
Article no
.
Connection
Image
IB 05 01 0H 2m PVC cable 1
IB 05 01 7H
M8
-
connector
2
Image 1
Image
2

MANUAL - Subject to alteration! Version: October 2017
ipf electronic gmbh │ Rosmarter Allee 14 - 58762 Altena - Germany │ Tel [phone] - [e-mail] -
www.ipf-electronic.com 2
Important note on in tallation:
Ensure the required clearances and s acing during
installation (Fig. 1).
If the device is to be installed in a fitting anel (e.g.
universal holder AY000115, see Fig. 2), roceed as
follows:
1. Attach the fitting anel to the intended location.
2. Screw the first nut onto the sensor, insert the sensor into
the corres onding mounting hole and then screw the
second nut onto the sensor. If the device is ex osed to
vibrations during subsequent o eration, the additional
use of s ring washers or toothed lock washers is
recommended during installation.
3. Select the mounting oint so that the distance to the
active surface is at least 7mm (Fig. 3).
4. Do not overrun the maximum tightening torque of
1.5Nm.
5. Already during mechanical installation, ay attention to
the alignment of the connector so that an angled cable
socket runs in the desired direction.
6. Only attach the cable socket after the mechanical
installation has been com leted and screw the union nut
tight. The maximum tightening torque is about 0.4Nm.
7. If you need to correct the alignment of an angled cable
box, loosen the mechanical fastening beforehand and
adjust the sensor (Fig. 4).
8. Provide suitable strain relief for the line so that any
vibrations are not transmitted to the device via the line.
SAFETY INSTRUCTIONS:
Before start-u , lease make sure that all safety instructions in the roduct documentation, if a licable,
have been observed!
In case of direct im act on ersonal safety, the a lication of these roducts is rohibited.
Fig. 1
Fig.
3
Fig. 2
Fig.
4