ipf MZR40787 User manual

MZR40787
TECHNICAL DATA
detection range 0 … 50mm
output signal 2 x pnp
operating voltage 12 ... 30V DC
residual ripple ≤ 10%
current consumption (w/o load) ≤ 15mA
output current (max. load) ≤ 100mA (2 x 50mA)
voltage drop (max. load) ≤ 2.2V DC
hysteresis typ. 4mm
repeatability ≤ 0.1mT (if UB and TA constant)
display (signal) 2 x LED yellow
short-circuit protection +
reverse polarity protection +
material (housing) plastic
dimensions 3.6 x 2.95 x 19.5mm
temperature (operating) -20 ... +75°C
degree of protection (EN 60529) IP67
shock and vibration resistance 30G, 11ms / 10 … 55Hz, 1mm
EMC resistance acc. to EN 60947-5-2
connection M8-cable connector 0.5m, 4-pin, rotatable thread
connection accessories e.g. VK200375
pin configuration dimensional drawing
C-groove
insertable from above
plastic housing
LED-display
short-circuit and reverse polarity protection
degree of protection IP67
wear-free cylinder sensor
2 teachable switching points
detection range 0 to 50mm
1: centre of sensor element 2:
fixing screw
3: LED 2
4: teach button
5: LED 1
6: fixing for cable straps
MANUAL • Subject to alteration! Version: July 2015
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel [phone] • Fax [phone]
│
[email protected] • www.ipf-electronic.com 1

Safety instructions
-Read the instruction manual carefully before operating!
-Mounting, installation and setting may only be carried out by qualified personnel!
-Never use these products in applications where the safety of a person depends on their functionality!
Notes
-Insert only anti-twist pistons on the cylinder!
-Use exclusively the enclosed hexagon socket key or a plastic pen!
-Check periodically the fittings and plug-in connections!
Start up 1. 2.
1. Insert the sensor from above at centre into the C-
groove and fix it with the enclosed hexagon socket key.
Pay attention on the centre of the sensor . The maximum
tightening torque is 0,1Nm.
Then connect the operating voltage (please note the
technical data and the connection diagram).
2. Teach-in of the switching points
-Determine the piston position for switching point 1.
-Press the teach-button for 3 seconds, LED 1 flashes.
-Release the teach-button, switching point 1 is
stored.
-LED 2 flashes.
-Determine the piston position for switching point 2 .
-Press briefly the teach-button, switching point 2 is
stored.
3. Control of the switching points
Move the piston into the position for switching point 1.
LED 1 has to light up. If it doesn’t light up, check the
operating conditions and teach the switching point
again.
Move the piston into the position for switching point 2.
LED 1 has to switch off and LED 2 has to light up.
If LED 1 doesn’t switch off or LED 2 dosn’t light up,
check the operating conditions and teach the device
again.
MANUAL • Subject to alteration! Version: July 2015
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel [phone] • Fax [phone]
│
[email protected] • www.ipf-electronic.com 2