IQBoard IQAio Sync Solution User manual

1
2
IQAio Sync Solution
1. Packing List
—Quick Guide—
2.Appearance
3.Installation
3.1 Draw the center line and the drilling horizontal line and the drilling position on the same horizontal on the
installation wall. Make sure the accuracy of correlative length is ±2mm.
3.2 After confirming the position of installation, use Φ8mm electric drill to make fourteen 80mm deep holes on the wall.
3.3 Insert the expansion rubber into the holes. Then install two fixed brackets B, two fixed brackets D, one hanging bar
and one stationary bar on the wall with self-tapping screw in the accessories box.
No.
Name
Specification
Quantity
1
IQAio
GR519
1
2
Green board
2031mm*1226mm
1
3
RFID card
Card
2
4
Colorless pen
10mm pen tip
2
5
Expansion bolts (self-tapping screws
and expansion rubber included)
M8*70
14
6
Round head screw with gasket
M4*16
8
7
Round head screw with gasket
M6*10
4
8
Fixed bracket B
70mm*42mm*58.2mm
2
9
Fixed bracket D
74mm*30mm*44.2mm
2
10
Hanging bar
200mm*47mm*42mm
1
11
Stationary bar
204mm*30mm*44.2mm
1
12
Power adapter
19V
1
13
Power cord
1.5m (wabbler)
1
14
Printer cable (A B Type USB cable)
2.5m
2
15
DB9 female head cable
Two DB9 heads,
L=3.0m
1
16
DB9 male to male switch head
Adapter converter
1
17
Quick guide
A4 size
1
18
Warranty card
150mm*75mm
1
19
Certificate
50mm*50mm
1
20
Whiteboard pen
Black
2
21
Eraser (optional)
120mm*50mm*35mm
1
22
Telescopic pointer (optional)
10mm pen tip
1
23
Wireless MIC (optional)
Charging cable and
headset included
1
24
Wireless keyboard & mouse
(optional)
Keyboard and mouse
1

3
4
3.4 Connect the cable of IQAio at the back. Then hang the IQAio directly on fixed bracket from top to bottom.
3.5 Connect the mother cable on the back of green board with the extended cable of IQAio and then hang the green
board on the fixed bracket.
3.6 Adjust the gap between IQAio and green board and keep in the same horizontal.
3.7 After confirming the proper position, fix four fixed brackets with four M4*16 round head screws with gasket. The installation is
complete.
3.8 If want to adjust the position again, put four M4*16 round head screws into the four mounting brackets (without fixed). Then
use M6*10 round head screw to adjust the position and fix the four M4*16 round head screws later. The installation is
complete.
4. Connection
[Kd159EN]-IQAio Sync Solution 20190816