IQBoard IQTouchOverlay DVT User manual

IQTouchOverlay
DVT
Installation Guide

Chapter1 Overview
1
NO. Touch Point The Number of Cameras Position of B-type USB cable at upper frame
1 2 pt 2 Upper left corner
2 10 pt 4 Upper right corner
Remark:
It’s recommended that the whiteboard should be larger than the DVT touch frame to ensure stable
installation.
The whiteboard should be flat and thick enough to avoid being distorted easily.
Keep the whiteboard surface and reflective strips clean to ensure smooth writing.
Keep the DVT touch frames installed horizontally
Chapter2 Accessory List
No. Name Quantity Remarks
1 IQTouchOverlay DVT(frame*4+cameras*4/2) 1 Standard Accessory
2 8m USB Cable 1 Standard Accessory
3 Certification 1 Standard Accessory
4 M4*10 Self-tapping Screws 32 Standard Accessory
5 Countersunk Head Screw 12 Standard Accessory
6 Installation Guide 1 Standard Accessory
7 Colorless Writing Pen 2 Standard Accessory
8 Soft Hotkeys 2 Standard Accessory
No. Name Quantity
1 Fixed Plate 8
2 Fixed Pieces for Lens 4
3 Upper and Bottom Frame 2
4 Left and Right Frame 2
5 Soft Hotkeys (left) 1
6 Soft Hotkeys (right) 1
Product Items (As Picture below)

Pic of 2-pt DVT touch frame for reference as below:
Pic of 10-pt DVT touch frame for reference as below:
2
1
5
4
6
4
12 2
3
1 12 2
3
Fixed Plate
Fixed three holeson each side
of the short frame at the back.
1
5
4
6
4
12 2
3
1 12 2
3
Fixed Plate
Fixed threeholeson each side
of the short frame at the back.

Chapter3 Installation Instruction
3.1 How to assemble the four DVT touch frames as one
Step1: Insert angle iron into overlays and fix them with screws.
Ensure that the front side of frame is flat without screws, as shown in the left image below.
The back side of frame with fixed screws should be close to the whiteboard as tight as possible and the white reflective
strip must face inside, as shown in the right image below.
Note:
3
Please follow steps below one by one to ensure the assemble in a right way.

3.2 How to assemble the DVT touch frame with the whiteboard
When the size of the whiteboard is larger than that of DVT touch frame, plz screw the brackets both on the frame and
whiteboard, as shown in the pic below. Ensure the distance between fixed brackets is the same as well.
Method1:
When the size of the whiteboard is the same as that of the DVT touch frame, plz screw two brackets at two sides and fix
the frame with whiteboard tight. Ensure the distance between fixed brackets is the same, as shown in the pic below.
Method2:
Make sure that the frame is placed horizontally during the installation.
The length and width of the specified board each should be 30mm wider than the frame.
Requirements of specified board: Surface roughness ≤2mm.
Note:
4

Chapter4 Solutions
3.3 Paste the hotkeys
Soft Hotkeys should be pasted on the margin area of whiteboard as shown below.
4.1 Combine with Whiteboard
5
The overlay DVT touch frame could combine with whiteboard, wall, ferrous metal surface and push-pull blackboard.

4.2 Combine with Wall
(Requirements of specified wall: Surface roughness ≤2mm.)
4.3 Combine with Push-pull Blackboard
The installation instruction could also be applied to the overlay which is magnetically mounted.
Notes:
6

[Kd046EN]-SKDDVT20170919