Hardware Information: Rear View
D-4: 15-pin power connector
D-5: 7-pin data connector
Hardware Information: HDD Tray
HDD Cage to 5.25” Bay Installation:
1. Install BPU-128DE-SS HDD cage to an available 5.25” bay from a system.
2. Secure the HDD cage on both sides with provided screws.
3. Connect two SATA power connectors to the HDD cage from the power supply.
4. Connect data cables to the HDD cage.
Accessories:
•Screws
2.5” SSD/HDD to tray Installation:
1. Insert slim 2.5” SSD/HDD into the tray.
2. Use provided screws to fasten SSD/HDD to the tray from bottom
3. Slide the HDD tray back to the HDD cage.
4. Repeat step 1 to 3 to finish the rest of HDD/SSD installation.
iStarUSAcare:
We will help you navigate our website to find the information that
you need. Go to www.istarusa.com, and click on live chat bubble
above the Search Bar
Our technicians are standing by to take your questions. Visit
http://istarusa.com/support/ , and you will receive a technical
support ticket to help track your requests from the beginning to the
end. Or you can contact us @ 888-989-1189
FCC and CE Radiation Norm
FCC
This equipment has been tested and found to comply with limits for Class B digital device pursuant to Part 15 of Federal Communications
Commission (FCC) rules.
CE
This equipment has been tested and found to comply with the limits of the European Council Directive on the approximation of the law of the member
states relating to electromagnetic compatibility (89/336/EEC) according to EN 55022 Class B.
FCC and CE Compliance Statement
These limits are designed to provide reasonable protection against frequency interference in residential installation. This equipment generates uses
and can radiate radio frequency energy, and if not installed or used in accordance with the instructions may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur in television reception, which can be determined by turning the
equipment off and on. The user is encouraged to try and correct the interference by one or more of the following measures: Reorient or relocate the
receiving antenna, Increase the separation between the equipment and the receiver, connect the equipment into an outlet on a circuit different from
that to which the receiver is connected to.
CAUTION!
The Federal Communications Commission warns the user that changes or modifications to the unit not expressly approved by the party responsible
for the compliance could void the user’s authority to operate the equipment.
