Itek I60020 Mounting instructions

BLUETOOTH
JUKEBOX
MODEL I60020
YOUR SAFETY &
INSTRUCTION MANUAL
PLEASE READ CAREFULLY
www.itek-products.co.uk

2
CUSTOMER SUPPORT TEAM: [phone]
TECHNICAL DATA
Description: Bluetooth Jukebox
Model: I60020
Product Rating: DC 12V 1.2A
Adaptor:
Input: AC 100-240V ~50/60Hz 0.45A
Output: DC 12V 1.2A
Radio FM Bandwidth: 87.5-108 MHz
DOCUMENTATION
We declare that this product conforms to the following product legislation in accordance with the
following directive(s):
2014/30/EU Electromagnetic Compatibility Directive.
2014/35/EU Low Voltage Directive.
2011/65/EU Restriction of Hazardous Substances Directive.
2014/53/EU Radio Equipment Directive.
RK Wholesale LTD Quality Assurance, United Kingdom
WARRANTY
This product is guaranteed for 12 months from the date of original purchase. If any defect arises due
to faulty materials of workmanship, the faulty products must be returned to the place of purchase.
Refund or replacement is at the discretion of the retailer.
The following conditions apply:
• The product must be returned to the retailer with proof of purchase.
• The product must be installed and used in accordance with the instructions contained in this
instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• RK Wholesale LTD has limited liability for incidental or consequential loss or damage.
• This guarantee is only Valid in the UK and Eire Only.
An extended warranty is available for this appliance.
See back page for details.

3
www.itek-products.co.uk
PRODUCT SAFETY
When using any electrical appliance, basic safety precautions should
always be followed including the following:
• Check that the voltage of the
main circuit corresponds with
the rating of the appliance
before operating.
• Please ensure that the appliance
is used on a stable, level, and
heat resistant surface.
• DO NOT immerse cords, plugs
or any part of the appliance in
water or any other liquid.
• DO NOT leave the appliance
unattended while it is operating.
• Close supervision is necessary
when any appliance is used by
or near children or pets.
• This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge
if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• Children shall not play with the
appliance.
• Cleaning and user maintenance
shall not be made by children
without supervision.
• Switch o at the wall socket
then remove the plug from
the socket when not in use or
before cleaning.
• If the supply cord or appliance
is damaged, stop using the
appliance immediately and seek
advice from the manufacturer
or its service agent or a similarly
qualied person.
• DO NOT let the cord hang over
the edge of a table or counter or
let it come into contact with any
hot surfaces.
• The use of accessory
attachments is not
recommended by the appliance
manufacturer apart from those
supplied with this product. DO
NOT use extension cords with
the appliance.
• DO NOT pull the plug out by the
cord as this may damage the
plug and/or the cable.
• DO NOT use this product for
anything other than its intended
use.
• This appliance is for household
use only.
• DO NOT carry the appliance by
the power cord.
• DO NOT use the appliance
outdoors.
HIGH VOLTAGE

4
CUSTOMER SUPPORT TEAM: [phone]
• DO NOT use in direct sunlight
• DO NOT use in wet or damp
conditions.
• DO NOT place the product on or
near sources of electromagnetic
pollution, vibration or where the
ventilation is poor as this may
cause damage to the product
or could interfere with other
products.
• DO NOT place containers lled
with water or any other liquid on
the top of the product as this
may damage the product.
• When handling electrical items
ensure that your hands are dry.
• Never disconnect the plug by
pulling the power cable as this
may damage the plug and/or
socket.
• If water has entered the body
of the product, please turn o
the mains at the wall socket,
and then consult a qualied
electrician for an inspection and
/or repair.
• Should the product malfunction
due to electrostatic discharge,
switch o at the wall socket and
allow 30 minutes for the charge
to dissipate before reconnecting
the power supply.
• Ensure that there are no metallic
objects placed in the internal
space of the product as this
may damage the product and
cause a risk of electric shock to
the user.
• In the unlikely event the
appliance develops a fault,
stop using it immediately and
seek advice from the Customer
Support Team.
Battery Safety
Always:
• Ensure the battery compartment
is secured.
• Only use the batteries
recommended.
• Ensure correct t of batteries.
Observe the plus and minus
marks on both the battery and
the compartment.
• Replace a full set of batteries at
one time.
• Store unused batteries in their
packaging and keep away from
metal objects that may cause a
short circuit.
• Remove dead batteries from the
equipment.
• Remove batteries from the
remote control if it is not to be
used for a long time.

5
www.itek-products.co.uk
• Remember to keep button cell
and batteries away from children
as they can easily be swallowed.
• Seek medical attention
immediately if batteries are
swallowed.
Never:
• Dispose of batteries in a re.
• Attempt to recharge ordinary
batteries.

6
CUSTOMER SUPPORT TEAM: [phone]
Main Unit
1. LCD Display
2. Control Panel
3. LED Lights
4. Speakers
5. Aux-in jacks/DC-in jack
(not shown)
Control Panel
1. LED display
2. Remote control sensor
(IR)
3. Standby
4. Source/LED ON/OFF
5. Tune-/ Skip backward
6. Volume –
7. Volume +
Rear Panel
1. Power
2. DC input socket
3. RCA L
4. RCA R
5. Aux-in jack
6. FM antenna
Remote Control
1. Standby
2. Mute
3. Skip backward
4. Play/Pause
5. Skip forward
6. Mode
7. LED ON/OFF
8. Treb+ eect
9. Treb- eect
10. Bass+ eect
11. Bass- eect
12. Volume+
13. Volume-
WHAT’S IN THE BOX
Instruction Manual
Speaker body
3.5MM Aux-in cable
Remote Control
Adaptor
5
3
4
2
1

7
www.itek-products.co.uk
BEFORE YOUR FIRST USE:
1. Remove the product from the box.
2. Remove any packaging from the product.
3. Please retain all packaging until you have
checked and counted all the parts and the
contents against the parts list.
4. Your appliance is now ready for normal
use.
Dispose of the packaging in a responsible
manner.
USING THE REMOTE CONTROL TO
OPERATE THE UNIT:
Aim the remote control directly at the remote
control sensor (IR) on the front panel. Don’t put
any objects between the remote control and
the system while operating the unit.
BATTERIES:
1. Slide out the battery
holder from the remote
control case. (Push tab
“A” towards the middle
rst, see diagram).
2. Place one 3V CR2025
(Lithium) battery into the
battery holder, observing
the polar marking. If
the battery is placed
incorrectly, the remote control will not
work. Dispose of the old battery properly.
Do not leave it lying around where a you
child or pet could play with or swallow it.
3. The battery may explode or leak if it is
mistreated. Do not attempt to recharge it
or disassemble it. Do not dispose of the
old battery in a re.
4. Insert the battery holder into the battery
compartment.
Note: Please remove all the batteries to
prevent damage or injury from battery leakage
if the unit will not be used for a long period of
time. Use only the specied size and type of
battery.
USING YOUR APPLIANCE
• Connecttheincludedmainspower
adaptorintotheDCinputsocketonthe
backofthejukeboxandthenplugthe
adaptorintothemainpowersupply
• Powerontheunit,movetheON/OFF
buttontotheleftsidetoturnthejukebox
on.Toturnito,pushtheswitchtothe
right.
• Toturnthejukeboxon,pressthe
Standbybuttononthecontrolpanelor
pressthestandbybuttonontheremote
control.
• ShortpresstheSource/LEDONOFF
buttononthecontrolpanelorusethe
Modebuttonontheremotecontrolto
movebetweentheFM,BT,Aux-inand
RCAmodes.
• AdjustthevolumeusingtheVolume+
andVolume-buttonsontheremote
controlorbypressingtheVolume+and
Volume-buttonsonthecontrolpanel.
• SwitchtheLEDlightsonoroby
pressingonthecontrolpanel,orby
pressingtheLEDON/OFFbuttononthe
remotecontrol.
• Setthejukeboxtostandbyonthe
controlpanelorbypressingtheStandby
buttonontheremotecontrol.

8
CUSTOMER SUPPORT TEAM: [phone]
Source/LED ON/OFF
Short press to switch between FM,BT, Aux-in
and RCA mode.
Long press to turn the lights on and o.
Tune-/ Skip backward
Short press to skip to the previous track or
chapters backward.
Long press to scan the radio station and save.
Tune+/ Skip forward
Short press to skip to the next track or
chapters forward.
Long press to scan the radio station and save.
Volume –
Press to decrease the volume.
Volume +
Press to increase the volume.
Playing the FM radio:
1. Press the Source button on the control
panel or press the “MODE” button on the
remote repeatedly until you have selected
FM mode.
2. Ensure the FM Antenna has been fully
extended
3. Press “Skip forward” and “Skip backward”
to select the desired FM radio station.
4. Long press and hold the “Skip forward” or
“Skip backward” buttons. The jukebox will
begin scanning for radio stations, and will
stop once it picks up a station.
Bluetooth:
1. Press the Source button on the control
panel or press “MODE” on the remote
repeatedly until “bt” appears on the LED
screen. The LED will ash until a device
has been paired with the speaker.
2. Long press Play/Pause on the remote
control to pair your device with the
jukebox. Enable bluetooth on your device
and select “I60020” from the listed
devices in the menu. When is pairing
successful, the “bt” LED icon on the
display will light up and you will hear “DU”
sound from the jukebox.
3. You can now play or skip songs using
your Bluetooth device, remote control or
jukebox control panel.
AUX-IN:
Requires a 3.5 mm cable (included).
1. Connect a 3.5 mm cable to the Aux-in
1 jack. Connect the other end of the 3.5
mm cable to a smart-phone or other
audio source.
2. Press the Source button on the control
panel or press the “MODE” button on the
remote repeatedly to select Aux-in mode.
3. You can now play or skip songs using
your Bluetooth device.
AUX-IN 2 RCA Connection:
Requires an RCA cable (not included).
1. Connect a 3.5 mm RCA cable to the Aux-
in 2 jack. Connect the other end of the
3.5 mm cable to an external Audio/Video
device such as a TV,DVD player etc.
2. Press the Source button on the control
panel or press the “MODE” button on the
remote repeatedly to select RCA mode.
3. You can now play or skip songs using
your audio device.

9
www.itek-products.co.uk
Changing LED light
1. To turn the LED lights on , press the LED
ON/OFF button once on the remote. To
turn the lights o, press the LED ON/OFF
button again.
2. Long press the LED ON/OFF button on
the control panel to turn the LED lights on
and o.
TROUBLESHOOTING
The following checks will assist in the
correction of most problems which you may
encounter with your set. Before going through
the check list below, rst check the following
points:
The power cord must be connected rmly.
Should any problem persist after you have
made these checks consult your nearest
dealer.
Problem Possible Causes and
Solutions
The jukebox has
no power.
Ensure that the adaptor has
been properly connected.
Check that the jukebox has
been switched on at the mains
power supply.
The jukebox
is not playing
sound.
Check that the volume level
is set at an audible level and
adjust accordingly.
Unable to pair
a Bluetooth
device.
Check if the device is
compatible with the jukebox
and ensure the Bluetooth
function on your device is
switched on.
The jukebox may not be set
to the correct mode. Press
the source button to select
the Bluetooth function – when
the Bluetooth indicator light is
ashing, search for ‘I60020’ on
your device.
The remote
control is not
working.
The battery may be exhausted.
Replace with a new battery.
Make sure the remote is
pointed at the jukebox during
use.
The sound is
distorted.
The volume or bass level
may be too high. Reduce the
volume and/or bass levels to
increase sound clarity.
Note: The normal function of the product
may be disturbed by strong Electro-Magnetic
Interference. If so, simply reset the product
to resume normal operation. If the issue
continues, please move the product to another
location.

10
CUSTOMER SUPPORT TEAM: [phone]
CLEANING & CARE
Cleaning the Jukebox:
• Always disconnect the equipment from
the power supply before cleaning.
• Clean the equipment with a soft, damp,
lint free cloth.
• Do not use abrasives or harsh cleaners.
WARNING:
DO NOT IMMERSE ANY ELECTRICAL PART
OF THE APPLIANCE IN WATER SUCH AS
MOTOR UNITS OR PLUGS.
PLEASE SEE CLEANING SECTION FOR
FURTHER INSTRUCTIONS.