iviewkorea T-F150IU User manual

DOC. NO.
RD-T-F150IU -H-001
REV.
PAGE DATE
T-F150IU
01 1 OF 10 2010,5,24
A4 (210mm×297mm)
Our Signature Design checked Approved
For
Customer Approval
lease return one of these to us immediately with your Signature for Approval
T-F150IU
15 inch
Infrared T pe Touch Screen
With USB interface
IVIEWKOREA
http://www.iviewkorea.com
Email: [email protected]
02. 2038. 8570

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 2 OF 10 2010,5,24
A4 (210mm×297mm)
Important
ImportantImportant
Important Information
InformationInformation
Information
Cop right
Copyright 2009 Hwayoung Systems Co., Ltd. ALL RIGHTS RESERVED
No part of this document may be copied or reproduced in any form by any means without prior written
consent of Hwayoung Systems Co., Ltd.
Hwayoung Systems Co., Ltd. makes no commitment to update or keep current the information contained
in this document. The information in this document is subject to change without notice.
All relevant issues have been considered in the preparation of this document. Should you notice an
omission or any questionable item in this document, please feel free to notify Hwayoung Systems Co.,
Ltd.
Regardless of the foregoing statement, Hwayoung Systems Co., Ltd. assumes no responsibility for any
errors that may appear in this document or for results obtained by the user as a result of using this
product.
Safet precautions
The safety recommendations outlined in this section are to be read, understood and followed before
operating the product.
Keep this information in a safe place for future reference.
Failure to comply with any of the following safety procedures could result in serious hazard.
 Do not operate product for any purposes other than its intended use.
 This product is intended for indoor use only.
 Do not operate product if power supply is damaged in anyway.
 Do not insert objects into openings.
 Do not immerse product in water or permit liquids to spill inside.
 Turn off power when unattended or not in use.
 Unplug product before moving or when not in use for an extended period of time.
 Install the product in a close and easily accessible socket-outlet.
 Do not alter or extend electric plug.
 lug is configured for appropriate electrical supply.
 Do not overload electrical outlets as this can result in a fire.

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 3 OF 10 2010,5,24
A4 (210mm×297mm)
Revision Histor
Rev Date Description Remark
01 2010,5,24 Start Ver 01
Note
NoteNote
Note
 The Components( Firmware, Hardware, Mechanical Design …) of This Product will be
Changed without any Customers Approval.

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 4 OF 10 2010,5,24
A4 (210mm×297mm)
Contents
1. Generals ---------------------------------------------------
2. S stem Block Diagram -------------------------------------
3. Specifications --------------------------------------------
4. Electrical & Environmental -------------------------------
5. Interface ( Connector )-------------------------------------
6. Dimension & View ------------------------------------------
7. Serial No Identification ----------------------------------
8. Cautions -----------------------------------------------------
9. Warrant ----------------------------------------------------
5
5
6
7
7
8
10
10
10

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 5 OF 10 2010,5,24
A4 (210mm×297mm)
1. Generals
1 .1 Overview
This manual is written to describe the model T-F150IU- 15 inch Infrared touch screen.
It refers to the general specification, connector functions and dimension.
lease contact us for more information on this product.
1.2 Features
 Infrared interruption detecting system with infrared sensors
 Input Mode: Finger, gloved hand or other stylus activation
2. S stem Block Diagram
USB
TOUCH
Infrared Touch anel
(15 inch)

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 6 OF 10 2010,5,24
A4 (210mm×297mm)
3. Specifications
3.1 Touch Matrix Panel ( TP150I6XXD + Mechanic ) - Tempered glass (3T)
Standard ) USB
Item Description
Interface USB2.0
Signal D+ , D- , VBUS, GND
Speed 12MBps (Full Speed)
Transfer Mode Interrupt Mode
3.2 Touch Interface Cable
Item
Description
Detection Infrared interruption detecting system with infrared sensors
Outline 359.4( H ) X 284.4 ( V ) X 10.2 ( H )
Detection Area 304.8 (H) X 228.8 (V)
㎜ ( Diagonal 15’’)
An optical element Space 6.0 (H) X 6.0 (V)
㎜
The number of optical elements 51 (H) X 38 (V) pcs
Touch plate Tempered glass (3T)
Scanning Rate Normal Mode : 20msec ( Typ )
Sleep Mode : 50msec ( Typ )

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 7 OF 10 2010,5,24
A4 (210mm×297mm)
4. Electrical & Environmental
Item Description
Supply voltage 5 Vdc ± 10%
ower consumption 2 [Watt]
Dimension 359.4 ( H ) x 284.4 ( V ) x 10.2 (D)
Accessory USB Cable
Temperature Operation : 0
～ 50 ℃
Storage : 0 ～ 50 ℃
Humidity
Operation : 0 ～ 90%
Storage : 0 ～ 95%
Resistance of ambient light Side light 5,000 Lx (incident angle 20°)
Front light 60,000 Lx (incident angle 90°)
5. Interface ( Connector )
5.1 USB interface - CN1 ( Molex-53261-10)
Pin No.
Description
Pin No.
Description
1 VCC
6 USB DP
2 Tx 7 Samba_Boot
3 Rx 8 OSD TD
4 GND
9 OSD RD
5 USB DM
10 GND

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 8 OF 10 2010,5,24
A4 (210mm×297mm)
6. Dimension & View
6.1 Front View

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 9 OF 10 2010,5,24
A4 (210mm×297mm)
6.2 Rear View

DOC. NO.
RD-T-F150IU-H-001
REV.
PAGE DATE
T-F150IU
01 10 OF 10
2010,5,24
A4 (210mm×297mm)
7. Serial Number Identification
The serial number shall be indicated on the back of the unit.
8. Caution
In order to maintain superior performance for the life of this product, customers are advised to maintain
the following guidelines:
8.1 Storage
 Do not store the product in humidity or temperature ranges exceeding those listed above.
 Do not store products out of original packaging.
 Do not expose product to direct sunlight.
8.2 Unpacking
 Do not attempt to dismantle or repair.
8.3 Handling
 Do not use product for any purpose outside its intended use.*
 Do not operate product if power supply is damaged in anyway.
 Do not insert objects into openings.
 Do not immerse product in water or spill liquids inside.
 Turn off power when unattended or not in use.
 Do not by the sharp edge on the screen.
 Do not stock product outside of packaging.
 Clean the screen with alcohol and a soft lint-free cloth**.
* This product is not intended for outdoor use.
** Do not allow alcohol to spill inside the product.
8.4 Assembling
 Avoid extreme pressure on the product.
 Avoid unnecessary strain to cables & connectors
9. Warrant
This product manufactured to this specification should be capable of meeting all characteristics for 18
Months from the delivery date of Hwayoung Systems Co., Ltd. when stored and used as specified in
this document.
Use of this product outside the specified criteria herein will negate the 18 Months warranty
The damages (defaults) described below are NOT covered under the warranty.
 User fault through lack of care.
 User fault through intentional dismantle or attempted repair.
 User fault by exceeding electrical connection requirements.
 Damage caused by natural disaster. (Fire, Flood, Earthquake, Lightening, etc.)
 Replacement of any parts.
yymm- ppp- vv- nnnn
yy : year
mm : month
ppp : part number ( 112 )
vv : version
nnnn : number of products produced