J.Burrows JB5TRHDSR User manual

JB5TRHDSR
5 SHELF UNIT
ASSEMBLY INSTRUCTIONS
1/4

2/4
Tools Required
Hardware List
PARTS INVENTORY CHECKLIST
5 Shelf
A Posts 8
B Shelves 8
C Beams 8
D Braces 8
E Post Caps 8
A
B
C
D
E
Alternative assembly configurations:

FOR SAFETY
·BE CAREFUL of sharp edges when assembling.
·DO NOT stand on this product or use as a ladder.
·DO NOT alter this product in any manner that is not
intended. This may cause product damage or personal
injury.
·Position the product on a level surface.
The maximum loaded weight for each shelf is no more than
350kg. evenly distributed.
When loading shelves, place heavier items on the lower
shelves, distributing the load evenly.
Fasten the unit to the wall whenever possible with proper
fasteners (not provided).
Assembly is done by fitting the rivets of the
beams and braces into the post slots.
Assemble two (2) posts with one (1) brace.
Skipping one slot from the bottom of the post
(A), place the rivets into post with the slot
pointing down, and with the shelf ledge of the
brace facing up (B). Tap lightly with rubber
mallet being sure the rivets are straight when
seating into slots. Repeat with two (2) post and
one (1) brace. Assemble the two post units with two
beams (C). Skip one hole from the bottom of
post, tap lightly to seat rivets.
B
C
A
Start by adding a shelf to the level previously built, then continue working by
adding the second level using two (2) beams and two (2) braces in the post slots
of your desired location.
Again place the rivets of the beams and braces
into the post slots with the shelf ledge facing up
and tap lightly to seat the rivets.
Add a shelf to the previously built level, then assemble the
top post to the bottom post by using two (2) beams and two
(2) braces. One (1) rivet from each beam and brace must
be placed in the top hole of the bottom post and the bottom
hole of the top post (D)
3/4
183cm H x 122cm W x 61cm D

When moving assembled unit,
always handle by the lower half.
Recheck all rivets being sure
they are securely seated.
Horizontal
Assembly
First and second slots
recommended
Optional Location
Add a shelf to the previously built level, then continue by
adding the fourth and fifth level to the unit using two beams
and two braces per level. Tap lightly to properly seat the rivets
and add the final shelves to the unit. Install all four end caps to
the top of the unit after assembly has been completed (E).
Install end caps to post by pressing down on ends.
D
E
4/4
For damaged or missing parts, please email [email protected]