J-Tech Digital JTD-178 User manual

JTD
-
178
| JTDSDI010
2
1X
2
SDI Splitter
User manual

1
Thank you for purchasing the J-Tech Digital JTDSDI0102. For optimum performance and safety, please
read these instructions carefully before connecting, operating or adjusting this product. Please keep this
manual for future reference.
I. Introduction
The JTDSDI0102 splitter distributes 1 SDI, HD-SDI or 3G-SDI video source to 2 SDI/HD-SDI/3G-SDI
displays simultaneously. This product features built-in automatic device identification and is compatible
with SD-SDI, HD-SDI, 3G-SDI formats of SDI signal. The JTDSDI0104 supports 2.97Gbps bandwidth,
and lossless transmission over long distances.

2
II. Features
1. 1 SDI input signal split to 2 SDI sink devices.
2. Supports SD-SDI (270Mb/s) | HD-SDI(1.485Gb/s) | 3G-SDI(2.97Gb/s) video formats.
3. Built-in cable equalization, clock recovery and drive.
4. Supports resolutions up to 1920x1080@60Hz.
5. Supports signal input and output distances of up to 984FT for SD signals, 656FT for HD signals
and 328FT for 3G signals.
6. Supports 5-12V wide voltage input.
III. Package
1. 1x2 JTDSDI0102 Splitter ---------------------------------------------------------------- 1PCS
2. 5V1A DC Power Supply Adapter ------------------------------------------------------- 1PCS
3. Operation Manual ------------------------------------------------------------------------- 1PCS

3
IV. Specifications
1. Frequency Bandwidth 3Gbps
2. SDI Splitter Input Ports 1 x BNC Female input port
3. SDI Splitter Output Ports 2 x BNC Female output ports
4. Power Supply DC 5V 1A
5. ESD Protection Human Body Model: ± 8kV (air-gap discharge)
± 4kV (contact discharge)
6. Dimensions (W x D x H) 2.75in x 5.70in x 0.98in
7. Weight 350g
8. Operating Temperature 0°C ~ 40°C / 32°F ~ 104°F
9. Storage Temperature -20°C ~ 60°C / -4°F ~ 140°F
10. Relative Humidity 20 ~ 90% RH (Non-condensing)
11. Power Consumption (Max) 1.5W

4
V. Operation Controls and Functions
Front Panel
1. ON/OFF: Power on/off switch.
2. POWER LED: This red LED illuminates when the device is connected to the power supply.
3. LOCK LED: This red LED illuminates when the SDI signal is detected.

5
Rear Panel
1. SDI INPUT: Use this port to connect the SDI source output from SDI Camera.
2. SDI OUTPUT: Use these ports to connect the SDI displays or monitors with coaxial cable (RG6).
3. DC 5V-12V: Plug the 5V or 12V DC power supply into the unit and connect the adapter to AC
wall outlet.

6
VI. Application Example

7
www.jtechdigital.com
Published by J-Tech Digital, Inc.
12803 Park One Drive
Sugar Land, TX 77478