4
ENGLISH
3.0 Safety
NB! To guarantee optimal performance and safety, Jøtul
recommends that its stoves are tted by a qualied
installer (see www.jotul.com for a complete list of dealers).
Any modications to the product may result in the product
and safety features not functioning as intended. The same
applies to the installation of accessories or optional extras not
supplied by Jøtul. This may also be the case if parts that are
essential to the functioning and safety of the replace have
been disassembled or removed.
In all these cases, the manufacturer is not responsible or liable
for the product and the right to make a complaint becomes null
and void.
3.1 Fire Prevention Measures
There is a certain element of danger every time you use
your replace. The following instructions must therefore be
followed:
• The minimum safety distances when installing and using
the replace are given in g. 1. The specied distance to
ammable materials, applies to this stove. The stove must
be installed with a CE approved ue. The distance of the
ue pipe to combustible materials must also be observed.
• Ensure that furniture and other ammable materials are not
too close to the replace. Flammable materials should not
be placed within 1000 mm of the replace.
• Allow the re to burn out. Never extinguish the ames with
water.
• The replace becomes hot when lit and may cause burns
if touched.
• Only remove ash when the replace is cold. Ash can contain
hot embers and should therefore be placed in a non-
ammable container.
• Ash should be placed outdoors or be emptied in a place
where it will not present a potential re hazard.
In case of chimney re:
• Close all hatches and vents.
• Keep the rebox door closed.
• Call the re service.
• Before use after a re an expert must check the replace
and the chimney in order to ensure that it is fully functional.
3.2 Floor
Foundation
You need to make sure the foundation is suitable for a replace.
See “2.0 Technical Data” for specied weight.
We recommend the removal of any ooring that is not attached
to the foundation (“oating oors”) beneath the installation.
Requirements for protection of wooden
ooring beneath the replace
The product can be placed directly on a wooden oor,
protected by a oor plate made from non combustible material
(recommended thickness - minimum 0,9 mm)
Jøtul recommends that any ooring made of combustible
material, such as linoleum, carpets, etc. should be removed
from under the oor plate.
Requirements for protection of
inammable oors in front of the replace
The front plate must comply with national laws and regulations.
Contact your local building authorities regarding restrictions
and installation requirements.
3.3 Walls
• The product should be placed so that it is possible to clean
the stove, ue pipe and chimney outlet.
• Make sure furniture and other combustible materials do not
get too close to the stove.
• Make sure furniture and other items are not placed too
close to the stove, to prevent them from drying out.
Distance to walls made of combustible material - see g. 1
The stove must be installed with a CE approved ue pipe.
The distance from ue pipes to combustible materials must
also be taken into account.
Combustible wall protected by rewall
Distance to combustible wall protected by rewall: See g. 1.
Distances with insulated chimney/shielded ue pipe are shown
in g. 1.
Non-combustible wall (all the way through)
The replace can be installed with a minimum of 150 mm to
non-combustible wall if the distance from the replace to all
combustible materials are a minimum of 500 mm.
Non-combustible materials mean materials like brick, clinker,
concrete, mineral wool, cilicate plates etc (materials that do
not burn). Note! A short distance to non-combustible wall
may lead to desiccation and discoloration of paint and cause
cracking.
3.4 Ceiling
There must be a minimum distance of 1200 mm to a
combustible ceiling above the replace.
