Jabra GN9330e - USB - Headset User manual

Set-Up Guide
GN9330e
Welcome to Microsoft Office Communicator!
Using this headset with Office Communicator will provide a simple, more consistent audio experience than using the microphone and speakers on your
computer (if available).You can also use this headset to answer calls on your Deskphone.
Setup Instructions:
1. Connect the power cable to the base and to a power
outlet.
2. Connect the USB cable to the base and to a USB port
on your PC.
3. Connect the two halves of the headset together (A).
4. Connect the headset to the base and allow to fully
charge. 4 green LED’s on the front of the base will
light up from left to right as the headset charges.
The headset is fully charged when all 4 LED’s are lit
(B) (this will take about 3 hours).
5. Open Communicator 2007.
6. Click the drop down arrow on the upper left corner.
7. Select the Tools option.
8. Select “Set Up Audio and Video…”
9. On the first pane you will set the Handset or Headset
you want to use. Make sure that Headset (GN9330)
is selected in the drop down menu.Then click Next.
10. Make sure the Headset (GN9330) is listed as your
speaker and microphone in the appropriate boxes.
(See graphic at right) You may need to set the top
drop down menu to Custom in order to change
these settings.Then click Next.
11 On this pane, you will set the audio output location
for your program sounds. It is recommended that
you use your PC speakers for this setting if you have
a sound card and speakers available.
12. When you have selected the output location,
click the Finish button.
TIP: The GN9330’s microphone can be
muted by pressing in on the volume
rocker on the headset. A red LED will
be lit on the base while the
microphone is muted (C).
A
Headset (GN9330e)
Microphone (GN9330e)

Set-Up Guide
GN9330e
Jabra®is a registered trademark of gN Netcom a/s
www.Jabra.com
To receive a call with Office Communicator
1.You will see a call notification on your computer
screen when you receive a telephone call.
2. If your headset is on base, remove it from the base
and the call will automatically be picked up.
3. If you are wearing the headset, answer the call by
either pressing the answer/release button on the
headset (A) or the one on the base (B).
4.You can also answer the call by clicking on the call
notification, but keep in mind that this will pick up
the call on the speakerphone device you setup in the
Setup Audio and Video wizard in Communicator.
To make a call with Office Communicator
One click calls:
1. Remove the headset from it from the base.It will
automatically start an audio connection with your
computer and you will hear dialtone. If you already
have the headset off the base but don’t have dialtone,
press the answer/release button on the headset (A)
or the one on the base (B). A blue LED will flash on
the headset and on the base (C) when the headset is
offhook.
2. Make one-click phone calls to contacts in your
contact list by selecting their name and clicking the
call button. A call window will pop up.
3.You can also call other numbers for a contact by
clicking the calling options arrow to the right of the
call button and choosing which number to call.
A
B
C
PRESS TO
ANSWER/END
VOLUME
CONTROL
AND PRESS
TO MUTE