Jaycar GG2402 User manual

Electric Skateboard
1
User Manual
Electric skateboard
Read before operating the skateboard

Electric Skateboard
2
Safety Warning
Whenever your ride a skateboard you risk death or
serious injury from loss of control, falls, road hazards,
and collisions. To ride safely, you must read and follow
all warnings and instructions contained in this manual.
Always wear safety equipment when riding including a
helmet, elbow pads, knee pads, gloves, eye protection,
and abrasion resistant clothing.
Do not ride in the rain, on wet surfaces, or on slippery
surfaces including as steel plates or manhole covers.
Avoid any obstacles and debris including parked cars,
rocks and gravel to avoid a loss of control.
Avoid uneven surfaces including cracks in the pavement,
curbs, heaved sidewalk joints, broken or missing
pavement/sidewalks sections, grates and drains. Avoid
riding in traffic, at night or in places where there is
limited visibility. Do not ride if you are under the
influence of drugs or alcohol.
Do not immerse or expose the skateboard to water.
Water causes
permanent damage to the skateboard that is not
covered by the warranty.

Electric Skateboard
3
Warning:
Do not ride an electric skateboard at speeds or down
hills where you would be unable to maintain control of a
normal non-motorized skateboard.
Do not touch the rear wheel, rear wheel hub or battery
case immediately after use. It is HOT and may burn you
or cause external injuries.
Keep out of reach from children under age 8. Children
under age 8 should never operate the electric
skateboard, it is not a toy

Electric Skateboard
4
Packing List
1.Skateboard
2.Charger of the skateboard
3.Remote Control
4.Charge cable of the Remote Control
5.User Manual

Electric Skateboard
5
Specifications
Specification
Size
Weight
870*245*180mm
5.5KG
Product
Performance
Load
Max speed
Up to 80 KG
20 km/h
Battery
Type
Standard Voltage
Capacity
Range
Brand
Lithium-ion
24V
2.2AH
8km
Samsung/LG
Motor
Power
150W
Charger
Input Voltage
Output current
Charge time
AC110~240V
1.5A
3 Hours
Control Model
Remote
2.4G RF Technology
Speed
Fast / Slow
Adjust By Switch
Wheel
Type
Size
PU
74*51mm
Packing box
Outer size
870*245*180mm

Electric Skateboard
6
Preparation
Check the switch of the handle/ skateboard in
place, as the diagram:
REMOTE CONTROL DIAGRAM
1.Power Switch
2.MINI USB Charging Port
3.Start/Brake switch
4.Speed switch(Slow/Fast)
5.Direction switch(Forward/Backward key)
6.Signal connection Indicator
7.Power Indicator 8.Reset

Electric Skateboard
7
PREPARATION
1. Make sure that the skateboard power switch in off
state.
2. Put the switch of “slow/fast”model to “slow”
mode on the handle.
3. Ensure the remote control was fully charged.
4. The Skateboard should be fully charged before
first use.
5. when the handle can’t use or invalid, click on
“Reset”to make it work(ensure the remote control
has power)
POWER INDICATOR
The remote control is build-in Li-polymer battery,
when it’s low power the green light on the remote
turns red, you should turn off the skateboard and
charge the remote control.
Please stop use the remote control when it’s low
charge.

Electric Skateboard
8
Operation
Start : when slide “power switch”, the “Forward
indicator”will be light(red indicator)
Forward & Backward Mode:
1.If want move forward, push the “start/brake switch”
and hold on the position, the skateboard will keep
moving forward; loosen your grip, the speed will
slow down, pull the back of key, it will be brake.
2. Switch the driving model to “backward/charging
indicator”, do the same operation as forward step.
Speed up
Brake
Brake
Speed up

Electric Skateboard
9
SLOW & FAST MODE:
1. Before start the skateboard, the switch key is on
the right side, it’s the “high gear”mode.
2. Switch key to right side, it will be in “slow”mode.
We strongly suggest beginner keep use of beginner
model.
Battery
1. Please use the matched lithium battery.
2. Please don’t place the battery under fire, water or
environment of extreme temperature.
3. Please don’t use the impacted or aging battery.
4. Please don’t put the charging batteries in easily
ignored places.
5. Please stop charge when the batteries are under
abnormal conditions such as heating.
Slow gear
High gear

Electric Skateboard
10
Maintenance, Repair,
and Disposal
Inspect your electric skateboard before every
ride to ensure it is in good operating condition.
Do not perform any maintenance or repair on
the battery case.
Warning: This product contains a Lithium Ion
battery that is considered a Class 9 (hazardous
material) and must be handled carefully. Do
not exposure to high temperature or fire.
Improper disposal can result in fire or
explosion.
Warning: The skateboard battery is not
replaceable, do not open the battery
compartment or attempt to change the battery.
Please consult your local regulations and
hazardous materials disposal service provider
for proper disposal instructions.