JBL CONTROL 1XTREME User manual

X + 0 + Y
2
0M
HZ
”
X + 0 + Y
2
X +
0 +
Y2
0
MHZ

SPEAKER PLACEMENT
WALL-MOUNTING
As front speakers.
(The Control 1Xtreme
speakers are video-shielded,
and may be placed near a
television or video monitor.)
45°
1. 5 -1.8 m
As rear speakers.
The Control 1Xtreme loudspeakers
may be wall-mounted. This
product is not intended for ceiling
mounting. Optional wall-mount
brackets are available from JBL.
Please contact your dealer, call
1-800-336-4JBL or visit our Web
site at www.jbl.com for a dealer
near you.
THANK YOU FOR CHOOSING JBL
For more than 50 years, JBL
has been involved in every
aspect of music and film
recording and reproduction,
from live performances to the
recordings you play in your
home, car or office.
We’re confident that the JBL
loudspeakers you have
chosen will provide every
note of enjoyment that you
expected – and that when you
think about purchasing
additional audio equipment for
your home, car or office, you
will once again choose JBL.
Please take a moment to
complete the enclosed
profile card. It enables us to
keep you posted on our latest
advancements, and helps us
to better understand our
customers and build
products that meet their
needs and expectations.
JBL Consumer Products

SPEAKER CONNECTIONS
TROUBLESHOOTING
Connections
– +– +
Front or Rear Speaker Outputs
LEFT RIGHT
LEFT RIGHT
–+–+
Front or Rear Channel Amplifier/Receiver Outputs
RIGHT LEFT
RIGHT LEFT
Wires
Speakers and electronics
terminals have corresponding
(+) and (–) terminals. It is
important to connect both
speakers identically: (+) on the
speaker to (+) on the amplifier
and (–) on the speaker to (–) on
the amplifier. Wiring “out of
phase” results in thin sound,
weak bass and a poor stereo
image.
If there is no sound from any of
the speakers:
• Check that the receiver/
amplifier is on and a source
is playing.
• Review proper operation of
your receiver/amplifier.
If there is no sound coming from
one speaker:
• Check the Balance control on
your receiver/amplifier.
• Check all wires and con-
nections between receiver/
amplifier and speakers.
• Make sure all wires are
connected. Make sure none of
the speaker wires are frayed,
cut or punctured.
If the system plays at low
volumes but shuts off as volume
is increased:
• Check all wires and con-
nections between receiver/
amplifier and speakers.
• Make sure all wires are con-
nected. Make sure none of the
speaker wires are frayed, cut
or punctured.
• If more than one pair of
speakers is being used, check
the minimum impedance
requirements of your
receiver/amplifier.
If there is no (or low) bass
output:
• Make sure the polarities (+ and –)
of the left and right Speaker
Inputs are connected properly.

JBL Consumer Products
250 Crossways Park Drive, Woodbury, NY 11797
8500 Balboa Boulevard, Northridge, CA 91329
800-336-4JBL (4525) (USA only)
www.jbl.com
©2002 JBL, Incorporated. JBL is a registered trademark
of JBL, Incorporated.
Part No.
C10032X
TWEETER TYPE: Titanium-laminate dome
DESIGN GOAL: Bring the thrill of live performance and movie sound to
the home environment by calling on JBL’s professional engineering leadership.
CROSSOVER NETWORK: Straight-Line Signal Path™ (SSP)
WOOFER TYPE: Shielded cone
ENCLOSURE DESIGN: Bass reflex
PROFESSIONAL REFERENCE: Studio Monitor
OWNER’S GUIDE PRO SOUND
COMES HOME™
PRODUCT LINE: CONTROL
®SERIES
MODEL
NUMBERS:
SPECIFICATIONS
Control 1Xtreme
Low-Frequency
Driver: 4" (100mm), Shielded
High-Frequency
Driver: 1/2" (12mm) Titanium-laminate, shielded
Frequency Response: 80Hz – 20kHz
Crossover Frequency: 4,000Hz
Recommended Amplifier
Power Range: 10 – 80 Watts RMS*
Sensitivity: 89dB
Nominal Impedance: 8 Ohms
Dimensions (H x W x D): 9" x 6-1/16" x 5-7/16"
228mm x 155mm x 139mm
Weight (each): 5.2 lb/2.4kg
*The maximum recommended amplifier power rating will ensure proper
system headroom to allow for occasional peaks. We do not recommend
sustained operation at these maximum power levels.
All features and specifications are subject to change without notice.
Notice to Purchaser: JBL assumes no responsibility or liability for injuries
or property damage – direct, indirect or consequential – resulting from
the improper installation of Control 1Xtreme loudspeakers.
We, Harman Consumer International
2, route de Tours
72500 Chateau-du-Loir
France
declare in own responsibility, that the
product described in this owner’s manual is
in compliance with technical standards:
EN 50081-1:1992
EN 50082-1:1997
Luc E. Godard
Harman Consumer International
Chateau-du-Loir, France. 1/02
Control 1Xtreme