JC HUMMINGBIRD Metal Tabletop Arch User manual

Metal Tabletop Arch Assembly Instructions
Please read all instructions carefully before use!
Important Safety Cautions to Reduce the Risk of Personal Injury or Product/Property Damage:
This product is not a toy and is
intended only for decorative purposes
with lightweight real or artificial
plants, flowers, and other wedding
arch decorations, or for decorative
purposes in training of climbing
plants. Do not use this product for any
other purposes.
Do not set or hang heavy objects on
this lightweight product. If
overloaded, it could collapse, causing
product/property damage or possible
personal injury.
Keep this product and all its small
parts out of the reach of children and
pets.
Do not stand or climb on this product.
Do not use this product as a ladder.
Securely attach and tighten all parts
of this product before use.
Properly secure the assembled arch to the floor by weight, cable, or other means or ground by
weight, cable, burying the bottom horizontal tubes or other means first before decorating it.
Free-standing installation is not recommended.
Package Contents: Please carefully check the contents against the parts table below.
Part No. Descriptions Quantities
1
16” strai
g
ht vertical frame tubes
8
2
12” horizontal support tubes with screw-nuts inside both ends
11
3
12
4
Screws
22
5
Complimentar
y
Screwdrive
r
and Ground Stakes
1&4

The basic joint structure is demonstrated:
1. Line up the parts and insert the narrow end of
#1 straight tube into the normal end of another
#1 tube.
2. Through the aligned holes screw #4 screw
securely into #2 support tube.
Replace #1 straight tube with #3 curved tube for
the top.
Assembly Instructions: Refer to the assembly drawing for the following steps. Ensure that the
tubes point in the direction shown.
1. Starting from the bottom right of the arch, begin assembly by inserting
a #1 straight tube into another #1 tube, and aligning the holes.
2. Insert a #4 screw into the aligned holes, attach a #2 tube as a crossbar
and securely tighten the screw with a screwdriver.
3. Repeat Step One & Two and attach the opposite side of #2 tube to
another pair of #1 tubes with the screw, forming the first rung of the
ladder-shaped assembly.
4. Screw a #2 support tube at
the bottom from both sides to
complete the bottom assembly.
5. Now for the top arch part, insert 2 #3
curved tubes to the top of the straight
“ladder” on either side, and screw them
together with 1 #2 support tube & 2 #4
screws.
6. Repeat Step Five 5 more times to complete the top arch.
7. Now carry on for the left side of the arch and repeat the steps
described in Steps One, Two, Three and Four to complete the whole
arch.
8. Tighten all the screws again to make the completed arch rigid.
Congratulations! Now the tabletop arch is ready for your decorations. Make sure to first secure the
arch to the tabletop/floor or ground properly – free standing is not recommended – before adding
lightweight decorations.
For additional indoor/outdoor wedding or garden applications, this product can
be configured as either a default taller round-top
arch or a wider flat-top arch by relocating 2 or 4 #1
straight tubes at the top middle of the arch.
Thank you very much!
If you have any questions or concerns with your
purchase, we would love to hear from you at
[email protected]