JDE Sprso Giro User manual

2021 - JDE Professional
Sprso Giro
Troubleshooting
Cleaning the coffee brewer
The coffee brewer can be fully disassembled, but this is not required when executing the cleaning procedure.
This simplifies the overall procedure.
Brewer part names (these are mentioned in the text)
1. Release knob (yellow)
2. Upper piston
3. Brewer chamber (with lower pistion inside)
4. Connection clip (geel)
5. Coffee tube
Cleaning procedure
Unlock the brewer: Press the
yellow release knob upwards.
Take the brewer out of the
machine; Take out the right part
first (upper piston).
Slide the brewer chamber from
the axle, and take it out.
Clean the brewer under a running
tap. Dry afterwards with a paper
towel.
NB. The brewer (parts) cannot be
cleaned in a dishwasher.
The yellow clip may be loosened
unintentionally. The clip can be
remounted as follows;
Guide the clip along the edge (on
the brewing chamber) as shown
here.






2021 - JDE Professional
Sprso Giro
Troubleshooting
Hinge the clip back, therewith
aligning the opening of the clip
with that of the brewing chamber.
Mount the brewer back in the
machine: Slide the brewing
chamber back onto the axle.
Slide the right part back in, and
press slightly until you notice a
clicking sound – the brewer is now
locked in place.
Remount the side panel.
The machine will prompt
periodically for cleaning with a
tablet (a cleaning tablet is then
inserted in the brewing chamber).
Follow the steps shown in the
display.