JETWAY HBFBU691 Series User manual

QIG for HBFBU691 Series
I. To Dissemble the Chassis
1. Put the system upon a stable platform with this side up, as the photo shows.
2. Locate the screws at the spots marked on the cover and both sides of the system and
unscrew them one by one.
3. Lift the cover up to open the chassis.
Left
Right

4.The internal structural view of the system for further intallation.
II. To Install SO-DIMM to the Board
1. Locate the SO-DIMM slot on the board.
2. Insert the gold-figure side of the compatible SO-DIMM into the slot at a 30 degree.

3. Press down to secure the SO-DIMM to the slot. The eject tabs will lock automatically if
installing direction is correct.
III. To Install Wi-Fi Card
1. Locate Mini-PCIe slot on the board.Remove the marked screw and use it to lock
compatible card to the slot in later installation.
2. Insert the gold-figure side of the compatible card into the slot and press down.

3. Secure the card to the board by tightening up the screw to the marked spot.
4. Locate the reserved antenna holes on the rear panel. Remove the dust-proof plugs on
the marked spots from the panel to install the antenna, as the following details show.
5. Push this antenna head into antenna hole of the rear panel from the backside of the
panel.
The washer①&the hexagonal screwnut②. Push the washer①through the antenna
head.
5-1
5-2

6.And then lock the antenna head to the front side of the rear panel with the hexagonal
screwnut②and tighten it up.
7. Press the metal hat on the end of the antenna string to corresponding antenna slot on
the card as shown.
8. The rear panel with antenna screwheads installed.

9. Connect the external Wi-Fi receiver antenna to the antenna screw head on the rear
panel.
IV. To Install MSATA Card
1.Locate Mini-SATA slot on the board.
2. Remove the marked screw and use it to lock MSATA card to the slot in later installation.

3. Insert the gold-figure side of compatible MSATA card into the slot and press down.
4. Lock the card to the board by tightening up the screw to the marked spot.