Juice Booster Instructions Juice Booster Instructions
First use and assembly
1. Intake part
2. Clear cover
3. Blade system
(push down firmly to fix in place)
4. Residue channel
5. Locking arms
6. Residue collector
7. Speed/Off Switch
8. Base part
9. Juice collection vessel
When you first use the
product you should assemble
as in the diagram, it is very
important to ensure that
the two locking arms (5) are
clipped into place, holding
the clear cover (2) and
therefore also the blade
system and residue channel
in place.
The Juice Booster has a
massive 65mm diameter
chute to juice apples…whole!
1
2
3
4
5
6 7 8 9
John Mills Limited JML House Regis Road London NW5 3EG
www.jmldirect.com
Guarantee:
This product is unconditionally guaranteed for one year against all
defects of workmanship and materials.
This guarantee does not effect your statutory rights.
If this product proves unsatisfactory please phone our dedicated
Customer Service team on 020 7691 3888 or write to John Mills Ltd.,
JML House, Regis Road, London NW5 3EG.
220-240v~50Hz 600W
The Juice Booster is a fun and easy way to help you get your
recommended five portions of fruit and vegetables everyday.
See www.5aday.nhs.uk/ for more details.
Use
• Assemble all the parts as in the diagram, then plug in the unit
(ensuring unit is switched OFF) and switch on at the wall.
• You should place the fruit or vegetable in the chute and place the intake
part (1) in the chute (there are guides inside the chute to ensure the
intake part stays straight).
• With your hand holding the intake part down, turn the switch to speed 1
or 2. 1is for softer foods and 2is for harder foods.
• Press down firmly on the intake part, the slower this part goes down, the
more juice you will get. Always use the intake part and never use hands
to push down food items.
• When the whole of the food is juiced, turn the unit off. If juicing lots of
fruits, do not leave switched on continuously for more than two minutes.
Leave to cool for at least one minute before using again.
Cleaning the Juice Booster
The unit must be switched off and unplugged before cleaning.
To clean the unit, disassemble. You may rinse parts 1, 2, 4, 6 and 9with
warm soapy water. Part 3, the Blade System, should be cleaned carefully
after use again with warm soapy water.
The Base Part (8) should be cleaned with a damp cloth and none of the
parts should be reassembled, plugged in or turned on until thoroughly dry.