DO NOT OVE FILL - Maximum capacity is 17 gallons.
DO NOT USE THE FLAMMABLE LIQUIDS.
USE EYE P OTECTION TO P EVENT PE SONAL INJU Y.
Keep the drain port clear of grease and dirt.
Optional Electric Pump is not self lubricating.
DO NOT UN PUMP D Y.
PARTS LIST ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
SAFETY & MAINTENANCE
Item No. Description Qty.
1. Low Profile reservoir 1
2. Mounting Plate 1
3. Handle 1
4. Filter Screen 1
5. Casters 4
6. Caster Nuts 4
7. Clevis Pin 2
8. Drain Hose 1
9. Ball alve 1
10. Hose Clip 1
11. 3/8” Barbed Hose Fitting 1
12. 1/2” x 3/8” Barbed Hose Fitting 1
13. Hose Clamp 2
emove all parts from and check against the parts list.
If anything is missing call TECHNICAL SE VICE at 1-800-433-0708.
Fig. 2
Fig. 1
Fig. 3
Fig. 4
3. 4. 6.
1.
5.
8.
7.
9.
2. 12.
13.
11.
1. Attach rear casters using caster nuts.
(See Fig. 3)
2. Attach front mounting plate and casters
using the caster nuts. Position mounting
plate as shown in Fig. 2 using the caster
and caster nut to secure it in place.
3. Attach one end of the drain hose to the 3/8”
barbed fitting on the drain body. Use a hose
clamp to secure.
4. Attach the 1/2” x 3/8” barbed hose fitting to
the other end of the hose - securing with a
hose clamp.
5. Attach the 1/2” ball valve fitting on the end
of the hose.
6. Secure the hose to the mounting plate using
the hose clip, nut and bolt.
7. Attach the handle to the mounting plate
using a clevis pin. (See Fig. 4)
8. Insert a clevis pin into the second hole
behind the handle. (See Fig. 3). This serves
as a handle stop.
9 Position the filler screen over the open tank
reservoir.
1. Make sure the ball valve on the end of the drain hose is in the closed position.
2. Position the drain under the vehicle being serviced.
3. To empty the drain - position the drain hose over the used fluid container and open the
ball valve.
4. When empty - close the ball valve.
