Joovv Elite
Quickstart Guide — Wall Setup
If you’d prefer instructional setup
videos, please visit:
www.joovv.com/setup
!Failure to securely install the anti-tip kit could could result in serious
injury. For comprehensive instructions, please review the product
manual that was included with your Joovv devices.
STEP 1
After assembling your Elite following the steps on the
opposite side, attach the included floor bumpers on the
bottom end caps. First, adjust the nut to the end of the
thread. Then insert the nut into the slotted hole and slide
forward into position. While pulling down to hold the nut
in position, twist the bumper clockwise to lock it in place,
as shown in Figure A.
STEP 2
Insert two threaded posts in to the top end caps using
the far left and far right holes. Then, attach one 90 mm
braided cable to each threaded post. Next, connect the
anti-tip bracket to each braided cable, and with a pencil,
mark the spot directly behind the threaded posts, as
shown in Figure B.
STEP 3
Next, remove the braided cables from the threaded post
and reposition your Elite to the side. Place the anti-tip
bracket on the wall with the center aligned with the
pencil marked location. Then mark each hole location
with a pencil. Drill a 7/32’’ hole for each marked hole and
insert the included wall anchors. Use a hammer to tap
the anchors into position, then attach the brackets to the
wall using the included screws, as shown in Figure C.
STEP 4
Place your Elite back into position and plug back in the
power cords and turn back on each device. Then, screw
the braided cables to the threaded posts securing your
Elite and you’re ready to start Joovvin’!
FIG. A
JV-MKTG-EQSG-03
