Joovv Max User manual

Joovv Max & Joovv Quad
Quickstart Guide — Wall Setup
If you’d prefer instructional setup
videos, please visit:
www.joovv.com/setup
!Failure to securely install the anti-tip kit could could result in serious
injury. For comprehensive instructions, please review the product
manual that was included with your Joovv devices.
JV-MKTG-QQSG-02
STEP 1
After assembling your Max or Quad following the
steps on the opposite side, attach the included floor
bumpers on the bottom end caps. First, insert the
end with the nut into the slotted hole and slide back
into position. Then, while pulling to hold the nut in
position, twist the bumper clockwise to lock it in
place, as shown in Figure A.
STEP 2
Insert the threaded posts into the far left and far
right positions on your Max or Quad system. Place
the system in position on the wall at the desired
location. Then, with a pencil, mark the spot directly
behind the threaded posts, as shown in Figure B.
STEP 3
Next, install the anti-tip bracket to the wall. Place
the bracket on the wall with the upper hole aligned
with the previously-marked location. Then mark the
lower hole position. Drill a 7/32” hole for all 4
locations for the included drywall anchors. Use a
hammer to tap the anchors into position, then
attach the brackets to the wall using the included
screws, as shown in Figure C.
STEP 4
Place your Max or Quad back into position and
screw in the end of the steel cables to the threaded
posts. Plug in the power cords and you’re ready to
start Joovvin’!
FIG. A
FIG. B
FIG. C

Joovv Elite
Quickstart Guide — Wall Setup
If you’d prefer instructional setup
videos, please visit:
www.joovv.com/setup
!Failure to securely install the anti-tip kit could could result in serious
injury. For comprehensive instructions, please review the product
manual that was included with your Joovv devices.
STEP 1
After assembling your Joovv Elite following the
steps on the opposite side, attach the included floor
bumpers on the bottom end caps. First, insert the
end with the nut into the slotted hole and slide back
into position. Then, while pulling to hold the nut in
position, twist the bumper clockwise to lock it in
place, as shown in Figure A.
STEP 1
After assembling your Joovv Elite following the
steps on the opposite side, attach the included floor
bumpers on the bottom end caps. First, insert the
end with the nut into the slotted hole and slide back
into position. Then, while pulling to hold the nut in
position, twist the bumper clockwise to lock it in
place, as shown in Figure A.
STEP 2
Insert the threaded posts into the far left and far
right positions on your Joovv Elite. Place the Joovv
Elite in position on the wall at the desired location.
Then, with a pencil, mark the spot directly behind
the threaded posts, as shown in Figure B.
STEP 3
Next, install the anti-tip bracket to the wall. Place
the bracket on the wall with the upper hole aligned
with the previously-marked location. Then mark the
lower hole position. Drill a 7/32” hole for all 4
locations for the included drywall anchors. Use a
hammer to tap the anchors into position, then
attach the brackets to the wall using the included
screws, as shown in Figure C.
STEP 4
Place your Joovv Elite back into position and screw
in the end of the steel cables to the threaded posts.
Plug in the power cords and you’re ready to start
Joovvin’!
FIG. A
FIG. B
FIG. C
JV-MKTG-EQSG-01