Jorvet Face Shield User manual

AB
Back of Shield
Step 5
Figure 1
Instruction Manual
Face Shield
Peel the protective film from both sides of the face shield and clear strap.
Slide the clear strap through the two slots on the shield.
Line up the holes in the shield and clear strap, and secure them in place by pushing a rivet through the holes on
both sides of the clear strap.
Insert the blue strap through slot A of the clear strap. Be sure end of the blue strap is inserted into slot A from the
front of the face shield.
Next, loop the blue strap through slot B. Be sure the end of the blue strap is on the inside, touching the head.
Repeat Steps 4 and 5 on the other end of the blue strap.
If necessary, adjust the length of the blue strap by pulling either end until the face shield is comfortable and secure.
Face shield assembly video:
https://www.jorvet.com/product/jorvet-face-shield-20-pk/
P. 800.525.5614 F. 970.663.5042 1450 N. Van Buren Avenue, Loveland, CO 80538
4
1
2
3
5
6
7
Step 1
Step 3
Step 2
Step 4
Step 3
Front of Shield
Step 5
Step 4
A B

Specifications
The JorVet Face Shield is designed to protect the eyes, nose, and mouth from aerosols, sprays, and splatters.
The Face Shield's full length provides complete coverage, and the wrap-around design provides over-the-top, side and
front face protection.
Material: PET-G Plastic
Color: Transparent
Face Shield Size:
• Width: 28 cm / 11 in
• Length: 20.3 cm / 8 in
• Thickness: 0.07 cm / .03 in
Manufactured and tested in accordance with the ANSI Z87.1-2015 standard. Type D3.
Care and Maintenance
Face shield can be cleaned with 70% ethanol or isopropyl alcohol, or with 6% bleach/water solution, or 3%
hydrogen peroxide.
DO NOT use ammonia or products that contain ammonia (such as common Windex window cleaner) - this will
cause the PET-G material to become brittle.
The face shield will last many months with proper care.
The face shield should be discarded if scratched or fogged (with harsh chemicals) or becomes brittle or breaks.
4
1
2
3
Each Face Shield is made proudly in Lawrenceville, GA.
Designed, Engineered &
Assembled Proudly in USA
JorVet Face Shield, 20 PK
Product Code: J1508