18 19
Setting the time
Pull the crown into position C. This stops the movement. You can now
set the required time. To achieve a time display that is as accurate as
possible, we recommend subsequently positioning the minute hand
in a backwards movement. This serves to minimise the degree of tol-
erance in the trains. Example: you wish to set the time as 10.10. Rotate
the minute hand clockwise until 10.20 is displayed, then set the time of
10.10 in anticlockwise direction.
Then move the crown back to position A.
Features and functions
Calibre J880.1 / J880.2
25FRE
7
3
11
10
8
2
6
4
5
ABC
9
1 Hour hand
2 Minute hand
3 Stopwatch second hand
4 Date display
5 Day of week display
(depending on model)
6 Crown
7 Second hand
(depending on model)
8 Minute counter
9 Hour counter
10 Start-stop button
11 Reset button
Note for models with second hand: to set the time precisely we
recommend stopping the movement when the second hand is over
the 60.
Setting the date and weekday (quick date reset)
Pull the crown to position B. First adjust the weekday by rotating the
crown counter-clockwise. Then set the date by rotating the crown
clockwise. Please note that the date should not be reset between 8pm
and 2am as the movement switches the date automatically during this
period and you could otherwise damage the switching mechanism. If
the month has less than 31 days, set the date manually to the 1st day
of the following month.
Using the chronoscope
Starting time measurement:
You start the chronoscope by pressing the start-stop button (10).
Stopping time measurement:
You stop the chronoscope by pressing the start-stop button (10) again.
Reset:
Press the reset button (11). This returns all three of the stopwatch
hands to their starting position.
Adding measured times:
After measuring the rst time, you can add times together by pressing
the start-stop button again instead of the reset button. The chrono-
scope hands will then continue running from the stopped position.
