
ENGLISH
3
How to reset our unit
• Your preset adjustments will also be erased.
How to forcibl eject a disc
• Be careful not to drop the disc when it ejects.
• If this does not work, reset your unit.
How to use functions mode
If you press M MODE, the unit goes into functions mode,
then the number buttons and 5/∞ buttons work as
different function buttons.
[Within 5 seconds...]
WARNINGS:
(To prevent accidents and damage)
• DO NOT install an unit or wire an cable in
a location where;
– it ma obstruct the steering wheel and
gearshift lever operations.
– it ma obstruct the operation of safet
devices such as air bags.
– it ma obstruct visibilit .
• DO NOT operate the unit while driving.
• If ou need to operate the unit while
driving, be sure to look around carefull .
• The driver must not watch the monitor
while driving.
If the parking brake is not engaged,
“DRIVER MUST NOT WATCH THE MONITOR
WHILE DRIVING.” appears on the monitor,
and no pla back picture will be shown.
– This warning appears onl when the
parking brake lead is connected to the
parking brake s stem built in the car
(refer to the Installation/Connection
Manual).
For safet ...
• Do not raise the olume le el too much, as this will
block outside sounds, making dri ing dangerous.
• Stop the car before performing any complicated
operations.
Temperature inside the car...
If you ha e parked the car for a long time in hot or cold
weather, wait until the temperature in the car becomes
normal before operating the unit.
EN02-07_KD-ADV5490[J]1.indd 3EN02-07_KD-ADV5490[J]1.indd 3 10/17/07 4:24:28 PM10/17/07 4:24:28 PM