JWA Funes 70406 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
Funes
70409/70406
TRUNDLE BED

PRE-ASSEMBLY PREPARATION
2
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
7.Assembly is to be carried out by a competent adult(s) ONLY
8.During assembly, children should be kept away from the product due to possible risk to
injury.
9.Do not use this item if any components are missing or damaged.
10.Please keep the instructions for future reference.
Allow 20 min For 2 person

3
PARTS LIST
1
Siderail
x 2pcs
4
Slat (905mm) x 12pcs
2
Cross Bar x 1pc
5
End Cap x 24pcs
3
Trundle Leg x 2pcs
6
Secure
Pin x 2pcs

4
STEP 1:
•Prepare a protected surface with a blanket or cardboard.
•Connect a side rail(1) to the trundle leg(3). Use bolt(A) per side,
and lock with nut(C). Fasten with allen key(D).
•Connect the other side rail(1) to the trundle leg(3). Use bolt(B)
and secure pin(6) per side, and lock with nut(C). Fasten with
allen key(D).
•Attach the cross bars(2) to the side rail(1), as shown below. Use
2x bolt(B). Fasten with allen key(D).

5
STEP 2:
•Attach an end cap(5) onto every slat, 2 per slat(4).
•Attach the slat to the bed as shown below. Push the caps into
the holes.

6
STEP 3: (Optional Step)

7
Assembly Is Complete

8
PRODUCT CARE:
FURNITURE / BED
1. When assembling your furniture / bed please ensure that you have
checked the contents for all relevant parts.
2. When tightening bolts make sure that they are fully tightened but not
forced.
3. When moving your fully assembled bed you must first remove the
mattress and lift the frame into position, take care when lifting and
always have two people handling the bed. PLEASE DO NOT DRAG THE
BED as this will cause damage to the rail.
4. It is advisable to use approved cleaning products when cleaning the
furniture and bed frame as certain chemical based cleaners could have
an adverse effect on the bed finish.