JWA COVE Sun Bed 68239 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
COVE
ITEM CODE:68239
Sun Bed

Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2.Take care when lifting. Product should be assembled as near as possible to the
point of use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
7.Assembly is to be carried out by a competent adult(s) ONLY
8.During assembly, children should be kept away from the product due to possible
risk to injury.
9.Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.
2
PRE-ASSEMBLY PREPARATION
Allow 45 min For 2 person

3
PARTS LIST

4
You will need
Step 1
•Prepare a floor or benchtop with a protective blanket or carboard.
•Prepare 6x bolt B sets by threading bolt(B) through washer(D).
•Connect the 2 seats(1)together, as shown below.
•Secure the 6 fixing points with bolts B sets for point. Insert the bolt
and washer on one side, lock it into place with a washer(D) and a
nut(C) on the reverse. Fasten with Allen key(E) and wrench(F).

5
You will need
Step 2
•With the aid of a 2nd person flip the frame over, as shown below.
•Insert the 2 backrests(2) as shown below, concave facing in. Push
the clip in, the backrest is only in when the clip springs out into the
aligned hole once inserted.

6
You will need
Step 3
•Insert the 2x right connecting rods(3) as shown below, concave
facing in. Push the clip in, the rod is only in when the clip springs out
into the aligned hole once inserted.
•Repeat for the 2x left connecting rods(4).

7
Step 4 You will need
•Pull the cloth cover(8) on one end over the connecting rods, as
shown below. Take note to have the holes on the cloth cover facing
down.
•Shuffle the cover down along the rods until the end of the rods
reach the first set of holes.

8
Step 5 You will need
•Thread the 2x connecting rods(5) one per side of the cover, through
the holes on the other end, as shown below.

9
Step 6
•Insert the connecting rod(5) into the right connecting rods on one
end. Push the clip down and connection is successful only when the
pin springs out through the hole. Do this for both sides.
•Then slip the cover over the other end until the holes line up wit the
end of the rods. Connect rods(5) to the other end.

10
Step 7
•Pull the cover down on both ends until it is taught. The connecting
points should be clearly in the holes of the cover. If not, shuffle the
cover until it is.