JWA Ridgeway 70904 User manual

ASSEMBLY INSTRUCTION
Ridgeway Coffee Table
ITEM CODE 70904
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
1

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assed hard surfaces that may
damage the product
2. Take care when li ing. Product should besible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instruc ons carefuginning assembly.
5. Keep all hardware parts and packaging oumall children.
6. Do not over  ghten the screws and bolts as thige the threads
7. Assembly is to be carried out by a compeLY
8. During assembly, childrenhe product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instruc ons for futu
Allow 30 min For 1 person Addi onal tools required
2

3
1 TOP PANEL
2 SIDE PANEL
3 SIDE PANEL
4 BACK PANEL
5 MIDDLE PANEL
6 BOTTOM PANEL
7 BASE PANEL
8 BASE PANEL
9 FEET
10 FEET
11 DRAWER SIDE PANEL
12 DRAWER SIDE PANEL
13 DRAWER BACE PANEL
14 DRAWER BOTTOM PANEL
15 DRAWER FRONT

4
L.
STEP 1:

STEP 2:
5

STEP 3:
6
STEP 4:

8
STEP 5:

9
STEP 6:
STEP 7:

STEP 8:
10

STEP 9:
11
STEP 10:
G

12
STEP 11:
STEP 12:

13
STEP 13:
STEP 14:

14
STEP 15:

15
ASSEMBLY COMPLETE
STEP 16:

SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
HARDWARE
Mounting Plate x 2 Wall Strap x 1 Large Screw x 2 Small Screw x 2
Back side
Wall
J
16

To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp materials (knife, fork, etc.) directly onto
your furniture as sharp material may scrape and damage the
finish.
•Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void
17