K-FEE Lattaero User manual

LATTAERO
MILK FROTHER
SWISS
ENGINEERED

3
Symbols and warning information ..............................................................Page
Safety information...................................................................................Page
Appliance overview..................................................................................Page
Initial start-up and preparation .................................................................Page
Cleaning................................................................................................Page
Frequently asked questions .......................................................................Page
Technical data / Service / Disposal information ............................................Page
3
3
7
8
10
12
13
This manual is a fixed part of this
equipment. The instructions and
safety information are provided
to use it safely. Disregarding them
can lead to hazards caused by
the appliance.
Please keep these instructions
safely and hand them over with
the appliance if it is passed on or
sold.
This appliance is designed for
frothing and/or heating milk as
described in the instructions.
It is exclusively intended for do-
mestic use only and for use in rest
areas and common rooms in oces
and shops and in accommodation
such as bed and breakfast, motels
or hotel rooms.
WARNING!
Electric shock
WARNING!
Scalding hazard
INFO!
General information
NOTE!
Recommended course of action
SAFETY INFORMATION!
This warning triangle is displayed at all places in this manual
where failure to observe the safety information could result in
hazards for the user or for the device.
Symbols and warning information
Contents
Safety Information

4 5
The manufacturer accepts no liabi-
lity for any consequences resulting
from commercial use, inappropri-
ate use or non-observance of the
instruction manual.
Operational requirements:
Ensure that the appliance is unda-
maged and in proper working order
before using it. Always use the ap-
pliance only with the base provi-
ded. Always disconnect a defective
appliance from the power supply
immediately and contact our custo-
mer service.
Place the appliance on a stable,
level and water-repellent surface
out of the reach of children.
Children shall not play with the
appliance. Children under 8 years
shall not use or clean the appliance.
Never place it on hot surfaces (e.g.
cookers or hotplates) and never
less than 50 cm from sources of fire
or heat (ie microwave ovens).
Before connecting the applian-
ce to the mains, ensure that the
mains voltage corresponds to the
voltage stated on the rating plate.
Do not operate the appliance from
within cupboard.
The appliance may only be connec-
ted to an earthed, three-pole
socket. Connecting to the electri-
city supply in any other way may
void the warranty. Ensure that the
mains cable is not damaged:
•
no contact with sharp-edged,
damp or hot objects
• do not place the unit on the cable
• do not pull the plug on the cable
out of the socket
• do not allow the cable to hang -
tripping hazard
If the supply cord is damaged, it
must be repaired by the manufac-
turer, its customer services or a
similarly qualified person before
using the appliance again.
Do not use the appliance outdoors.
Never attempt to open it - hazar-
dous voltage inside!
Ensure that no liquid boils over
onto the base with the mains plug
and the base connector - risk of
electric shock!
This device may be used by child-
ren of 8 years and above and also
by persons with limited physical,
sensory or mental capabilities or
a lack of knowledge or experience
provided that they are supervised
or that they have been adequately
instructed in the safe use of the
appliance and have understood
the potential hazards involved.
Children must be 8 years of age or
older and under permanent super-
vision when carrying out cleaning
and user maintenance.
Avoid scalding or injury:
Never leave the device unsupervi-
sed while it is in operation. Never
open the lid while it is in operation
as this poses a risk of scalding.
Touch the appliance only on suita-
ble and properly protected surfa-
ces. Move it with extreme caution
when it contains hot liquid.
Do not open it and ensure that
children do not insert any objects
into the openings. Do not overfill
the milk frother.
Cleaning and Maintenance:
Unplug the appliance before clea-
ning and allow it to cool down.
Before cleaning, remove the jug
from the base.
Safety Information Safety Information

6 7
Components:
1 Lid
2 Seal ring
3 Whisk for all milk
preparations
4 Jug
5 Bottom connector
6 Base connector
7 Base with mains plug
Controls:
8 Warm creamy milk
frothing
9 Warm firm milk
frothing
10 Warm milk
11 Cold milk frothing
Do not wet-clean the power cable,
power plug or base unit; do not
place them under running water
and do not immerse in liquid.
Do not use abrasive cloths, scou-
ring agents, brushes or sharp
objects for cleaning that could
damage the coating. Only use wa-
ter, dish soap and a mild cloth.
The jug is suitable for washing in a
dishwasher at temperatures up to
70°C.
Do not put the base in the dish-
washer under any circumstances!
After cleaning, ensure that the
bottom of the jug and the bot-
tom connector are absolutely dry
before you replace it on the base -
risk of electric shock.
If you are absent for extended
periods and at the end of each day,
unplug the unit from the power
socket.
Apart from routine frothing and
maintenance operations, all mea-
sures such as repairs or exchan-
ging the mains cable should be
performed only by a customer
service authorised by the manu-
facturer.
This manual is also available on:
www.k-fee.com.au
1
3
6
5
4
7
8 9 10 11
2
Safety Information Appliance overview and scope of supply

8 9
2Insert the whisk back into the milk
frother. Connect the base back to the
power supply.
3Fill milk into the jug and respect the
capacity limits: for hot milk do not pass
the upper „MAX“, for milk froth do not
pass the lower „MAX“. Never undercut the
„MIN“ limit.
4Place the filled jug on the base and put
the lid on it. All buttons light up.
5Choose your required milk preparation
by pressing the appropriate button. The
button blinks during preparation. When
the blinking stops the froth is ready. To
interrupt operation, press the selected
button again or lift the jug from the base.
Preparation times:
Cold milk froth approx. 80 seconds, warm
milk and warm froth approx. 120 seconds.
6Pour the finished milk or froth into a
cup or glass.
CAUTION: Do not use a metal spoon to
empty the jug as this may damage the
coating!
1Take the jug from the base unit. Remo-
ve the lid, sealing ring and whisk from the
milk frother.
Clean all parts as described in the cleaning
instructions (see pages 10-11).
SAFETY INFORMATION!
Before the first use, it is impe-
rative to read the safety infor-
mation on pages 3-6.
WARNING!
Place the base on a dry, level
surface that cannot become
hot. Ensure that the bottom of the milk
frother is kept dry to prevent the risk of
electric shock.
SAFETY INFORMATION!
1. Never remove the whisk
while the unit is in operation.
Doing so may cause the coating to burn.
2. Do not add ingredients such as syrups
or sugar directly to the jug.
WARNING!
Before operating the applian-
ce, check that the mains vol-
tage corresponds to that stated on the
rating plate (underside of appliance).
INFO! The milk frother swit-
ches itself OFF automatically
after two minutes. To switch it
ON again, press one of the four buttons.
Always use cold, fresh milk
(whole or semi-skimmed) from
the refrigerator (4-6°C).
Do not use enriched or flavoured milk
or milk prepared from powder. For
hygienic reasons, put the milk back in
the refrigerator after use.
4
3
280 ml
180 ml
2
Initial start-up and preparation Initial start-up and preparation