The following problems will occur due to the inevitable falling of articles during transportation:
When the machine is received, the heating pipe does not work in two
cases:
1. The heating tube glass tube is broken due to the vibration during
logistics transportation, and the heating tube cannot work.
2. The heating wire is broken due to vibration during logistics
transportation, and the heating pipe cannot work after 1-3 timesof
using the machine.
Please be sure to confirm receipt after unpacking inspection. If
the shell is bumped, contact customer service to send a new shell.
(If the paint is knocked off in special parts, contact the customer
service to replace the machine)
In order to ensure the safety of use and avoid causing injury and property loss to you and others
●
●
●
●
●
●
●
●
●
●
●
Important note:
warning
Do not open the rear cover plate when power is on. Non professionals shall not carry out
live maintenance.When replacing accessories, unplug the power plug before opening the
rear cover plate. Only aer the replacement is completed can the machine be plugged in and tested.
Over roasting of coffee beans is prohibited.
Safety warnings must be learned. It is forbidden for non learners to operate the baking
machine. Children should stay away from the baking machine.
Do not wet the power socket with water.
Please do not leave during roasting!Avoid excessive heating and burning of coffee beans
due to no supervision.
When heating, the bean bin must be stirred, otherwise the bean bin will be deformed due
to excessive heat on one side.
The set bean temperature should not exceed degrees.230
The silver peel of coffee beans collected should be cleaned in time to avoid burning due to
the accumulation of silver peel.
The device must be placed in a well-ventilated place, and no flammable materials behind.
Do not cover the .exhaust vents
During the baking and heating, the surface temperature of the
equipment is high.Do not touch the surface of the device to avoid
burns. (The red area is the high temperature area)
After roasting is completed, and stirr the bean cabin turn on the
exhaust smoke.And turned off the roaster after temperature of the
beans drops .below 50 degrees
The new equipment will have some smell of the spray paint, and it
will dispel after baking times.2-3
High
temperature
area
