Kargo Master 4081SF Manual

Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
20210930R1 DATE: ________________
Instruction Guide
4081SF

Instructions –4081SF
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 1
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING,
AND USING THIS PRODUCT. *
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF.
Tools Needed
1/2”, 9/16” Sockets and Wrench
Tape Measure
Table of Contents
Before You Begin............................................................................................................................................... 1
Parts .................................................................................................................................................................. 2
Hardware .......................................................................................................................................................... 2
Step 1 –Install Feet to Factory Rails................................................................................................................. 3
Step 2 –Install Rack to Feet.............................................................................................................................. 5
Before You Begin
Read all instructions prior to assembling or installing any Kargo Master product.
Always locate your installation locations prior to performing any work.
ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE.
Refer to assembly instructions provided with rack to assemble rack. It is recommended to have the rack
assembled before installation.

Instructions –4081SF
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2
Parts
Hardware

Instructions –4081SF
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3
DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF
Step 1 –Install Feet to Factory Rails
Measure the bow center to bow center distance on rack being installed. Standard bow-to-bow distances
are 71-1/2” or 96”.
Slide a rail slider into factory
rail on one side of vehicle.
Set foot over rail slider studs with saddle in foot
towards center of vehicle.
LOOSELY attach a 5/16”washer and 5/16” lock nut to
each stud.
Repeat for second foot.

Instructions –4081SF
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 4
Position feet center-to-center at the distance measured previously.
oStandard bow-to-bow distances are 71-1/2” or 96”.
oRear foot should be about 12” to 14” inches from the rear of vehicle for rack handle clearance.
Loosely tighten hardware.
Repeat for opposite side.
12”-14”

Instructions –4081SF
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 5
Step 2 –Install Rack to Feet
Set rack on feet. Center rack to vehicle.
Using 3/8” x 1” hex head bolts, 3/8” lock washers, and 3/8” flat washers, install rack bows to feet.
Square and align rack to vehicle.
Tighten hardware.
GO BACK AND TIGHTEN ALL HARDWARE.
ASSEMBLY AND INSTALLATION ARE COMPLETE.
Center rack to vehicle.