Kasta KB36RGBTWS5M User manual
PRODUCT CODE: KB36RGBTWS5M
FEATURES
•Complies to Australian Standards AS/NZS 60669.2.1:2013,
AS/NZS 60598.2.1:2014, AS/NZS 60598.1:2017.
•No user serviceable parts inside.
Smart RGBTW LED
Strip Light Kit, 5m
Visit www.kasta.com.au or your app store to download the free
KASTA app.
iOS: requires iOS 9.0 or later.
Android: requires Android 4.4 or later.
Devices must support Bluetooth 4.0
APP INSTALLATION
IMPORTANT SAFETY INFORMATION
TECHNICAL SPECIFICATIONS
CONNECTION DIAGRAM
• Remote controllable RGB Tuneable White LED strip kit
• Wireless Bluetooth Mesh communication
• Can be paired with KASTA remote switches for
operation (8x maximum per kit)
• Configured and controlled using the KASTA app
(iOS and Android)
• Supports Group, Scene, Timer and Scheduling
automation functions
• 3 year warranty
Supply
220 - 240V a.c.
Output
2A/CH, MAX. 6A
Operating Frequency
2.4Ghz
Operating Temp
-20ºc to 40ºc
N
A
.....................................................................................................
ON/OFF 1 CLICK
DIM UP/DOWN ONE LONG PRESS
Turns lights on or o. When turned ON, lights will
adjust to previous brightness setting.
When lights are on, long press button to dim up or down.
Release button to stop.
FUNCTION SETUP
The KASTA app must be used to create and build the Bluetooth mesh
network, where devices are added and options are configured.
Once complete, users have control from either KASTA devices
directly or from the app.
CONFIGURATION
RGB AND COLOUR
TEMPERATURE
LED STRIP
LED CV DRIVER
(24V)
LED STRIP
CONTROLLER
FULL BRIGHTNESS 2 CLICKS
SET COLOUR TEMPERATURE 4 CLICKS*
FACTORY RESET 9 CLICKS
Sets lights to full brightness.
DELAY TO OFF 3 CLICKS*
Lights automatically turns o after set time.
Cycle through to desired colour temperature. Click button 1 time to store setting.
SET RGB COLOUR 5 CLICKS*
Cycle through to desired colour. Click button 1 time to store setting.
Restores all settings back to factory.
*If successful, light will pulse the number of times that the
switch was clicked, indicating function.
Controllable via KASTA remote switches or RESET button on
LED Strip Controller
ver 1.0
Peel o backing tape and
fix into position.
Ensure that surface is clean and dry by
using an isopropol alcohol.
Suitable for mounting on
normally flammable surfaces
Cut strip to length at indicated intervals
(every 167mm) using a sharp knife or
scissors . Ensure care is taken to avoid
damage to terminals.
Contents
Connect strip to strip controller driver.
Fix controller to surface with screws.
x20
12
Apply silicone to end of strip.
7
45
RESET
INPUT
OUTPUT
Connect strip to driver.
Fix driver to surface with screws.
8
INSTALLATION
x2
Secure strip by fastening
saddles to surface.
6
3
Press End Cap onto end of strip.
Ensure full coverage to
maintain IP54 rating.
