kchibo KK-E160 User manual

KK-E160 Operating Instructions
Radio design :
1. LCD Display 11. Power / Sleep
2. Reset 12. Band/ Mode
3. M - 13. Down
4. Key Lock 14. Antenna -
5. Night Light 15. Supporting Rack
6. M + 16. Hand strap
7. Scan / AL. On/Off 17. Earphone
8. Volume Control 18. D.C. Jack
9. Memory 19. Battery Compartment
10. Up
Battery Installation :
1. Please install 2AA batteries.
2. Please replace batteries if the volume is too low.
3. Please replace your batteries within 30 seconds, otherwise all memory will be lost.
Radio Reception :

Power On/Off
Press the Power (11) button to turn on or off the radio.
Volume Control
Rotate the Volume Tuning knob (8) to adjust the volume.
Band Selection:
Under the radio mode, press the Band button (12) to switch between FM, MW and SW.
Frequency Step :
FM : 0.1MHz
MW : 9KHz
SW : 0.005MHz
Auto Search :
1. Turn on the radio
2. Select the band.
3. Press Up (10) or Down(13) for 2 seconds. Scanning will stop at the next station.
4. Press Up (10) / Down(13) anytime to stop the searching process.
Manual Search :
1. Turn on the radio
2. Select the band
3. Press Up (10) or Down (13) until you locate the station. For each time you press, the frequency
will increase or decrease by one step.
Auto Scan and Store :
1. Under the radio mode, press the scan button (7) , the radio will automatically search and store all
channels until memory full.
2. You may stop the search anytime by press the scan button (7) again.
Memory Presets :
1. Use auto or manual search to locate the station.
2. Press the MEMORY button (9) , the LCD indicator will blink.
3. Press M+(6) or M-(3) to select the channel. Press the Memory button (9) again to confirm.
Memory Recall :

Under the radio mode, press the Band (12) button to select the band. Press the M+ (6) or M-(3) to
select the stored channel.
Use of Antenna :
1. AM : The built-in magnetic antenna inside the radio is used. Rotate body to get best reception.
2. FM : Extend the antenna. Try different angles to get the best reception
3. SW : Extend the antenna.
Time setting :
This unit adopts 24 hours system.
1. When batteries are is installed, the “12:00” will display.
2. Under the clock mode, press the Mode (12) button . The hour digit will blink. Press the Up (10) or
Down (13) button to set the hour . Long press for fast moving.
3. Press the Mode (12) button again. The minute digit will blink. Press the Up (10) or Down (13)
button to set the minute.
Alarm Set :
Alarm Time Setting :
1. Under the clock mode, press Mode button (12) three times . You will see the alarm icon and hour
digit blinks. Press the Up (10) or Down (13) to set the hour.
2. Press the Mode button (12) again , the minute digit will blink. Press the Up (10) or Down(13) to
set the minute.
Alarm On/Off
1. Under the clock mode , Press the AL ON/OFF(7) button to turn on the alarm .
2. The radio will turn on at the preset time.
3. The radio will turn off after two hours’ operation.
Sleep Function :
1. Under the clock mode , long press Sleep (11) button once to turn on the radio. The sleep icon and
“90” min will appear.
2. Press Sleep (11) button again to adjust the sleep time in the following order :
90-80-70-60-50-40-30-20-10- cancel . The radio will shut off at the preset time.
3. You can turn off the radio by press the Power(11) button if you would like to turn off the radio
early.

Specifications :
1. Frequency Range
oFM 87.50 -108 MHz
oAM 522 - 1611 KHz
oSW 5.95 – 17.90 MHz
2. Memory preset (30)
oFM (10), AM(10) , SW(10)
3. Noise Limit Sensitivity
oFM <= 20dBu
oAM < = 5mV/m
oSW <= 40dBu
4. Single Signal Selectivity >=10dB
5. Power : DC 3V or 2 x AA batteries (not included)
6. Speaker : 45mm/8ohm/0.5W
7. Earphone jack : 3.5mm 32ohm
8. Measurement : 110 x 67 x 24 mm
9. Weight : 135g (excluding batteries)