
The Electronic Filter
is
designed so that it can
be
cleaned
using Zap-It! or common household detergents. Use dish
washing detergent and hot water, make a good soaking
solution. Completely immerse the Electronic Filter and soak
for 20 to 30 minutes. After the Electronic Filter has soaked
sufficiently, it should be gently agitated
in
the water until
clean. Ifthe Electronic Filter
is
extremely dirty, spray it with
Zap-It, a cleaning solution made specifically for this air
cleaner. (You can also use a common household cleaner.)
Let the filter soak for five minutes then proceed with the
washing instructions.
Thoroughly rinse both sides ofthe Electronic Filter. If a
sprayer is available, spray with water. Check to make sure
each layer of the Electronic Filter
is
clean. Shake
as
much
water out
of
the Electronic Filter
as
possible. Wipe along
the ionizing wires carefully with a cotton swab and alcohol.
After reinstalling the Electronic Filter, operate the unit
in
the
Dryposition for one hour to ensure that
it
is
thoroughly dry.
Failure to do so can cause permanent damage to
Electronic Filter.
Washing Tips:
When handling the Electronic Filter,
be
careful
not
to
damage wires
or
metal
plates since this
could
cause
excessive
snapping
.
After
the first cleaning, the
metal
surface
of
the Electronic
Filter
may
not
be
as
shiny
as
before. This is normal
and
does
not
reduce effectiveness.
Cleaning the Negative
lon
Generator Needle
The Negative
Jon
Generator needle should be cleaned
about once every two months. Make sure the air cleaner
is
turned off and unplugged from the outlet for 5 minutes
before cleaning the needle.
To clean the needle, simply wipe it with a cotton swab
dipped in alcohol. Then use a dry cotton swab to make
sure the needle is dry.
NEGAT
IVE
ION
GENERATOR
The
Pre-Filter
The Pre-Filter
is
located in the front of the Electronic Filter.
To clean it, slide it out and rinse thoroughly with clean
warm water. Set it aside to dry.
The Charcoal Filter
Although the Charcoal Filter is an optional replacement
filter, we recommend its use for the operation of your air
cleaner to help maintain efficiency.
During normal use, lint and dirt may build up on the Char-
coal Filter and can be removed with a vacuum cleaner
using a brush attachment.
The effectiveness ofthis Charcoal Filter will gradually
diminish over time. If your unit
is
used continuously, it
should be replaced every three months. Replacement
filters are available at Sears retail stores.
Reinstalling
the
Electronic
Filter
First, slide the Pre-Filter into the slots
in
the front of the
Electronic Filter and slide the Charcoal Filter into the slots
provided
in
the back. Using the handles, align the
Electronic Filter with the ribs on the inside cabinet wall.
Gently slide the Electronic Filter into place.
Note: The label on top
of
the Electronic Filter will
help
you
replace the Pre-Filter
and
Charcoal
Filter into the Electronic
Filter.